Search results
Results from the WOW.Com Content Network
An amateur radio repeater system consisting of a 70 cm repeater and a 2-meter digipeater and iGate. Coaxial cavity RF filter at 2 meter repeater An amateur radio repeater is an electronic device that receives a weak or low-level amateur radio signal and retransmits it at a higher level or higher power, so that the signal can cover longer ...
The Western Union company used the term simplex when describing the half-duplex and simplex capacity of their new transatlantic telegraph cable completed between Newfoundland and the Azores in 1928. [4] The same definition for a simplex radio channel was used by the National Fire Protection Association in 2002. [5]
For example, in US two-way radio, 30–50 MHz is one band and 150–174 MHz is another. A repeater with an input of 33.980 MHz and an output of 46.140 MHz is a same band repeater. In same band repeaters, a central design problem is keeping the repeater's own transmitter from interfering with the receiver.
RFinder's main service is the World Wide Repeater Directory (WWRD), which is a directory of amateur radio repeaters. RFinder is the official repeater directory of several amateur radio associations. RFinder has listings for several amateur radio modes , including FM , D-STAR , DMR , and ATV .
Repeater equipment: GMSK Node Adapter - these devices are hardware GMSK modems with firmware to take D-STAR protocol frames over a USB cable and provide the necessary logic and GMSK modulation to control a simplex node or a full duplex repeater. One repeater that is easily adaptable is the Kenwood TKR-820 as documented by K7VE. [27]
Continental Electronics is an American manufacturer of broadcast and military radio transmitters, based in Dallas, Texas.Although Continental today is best known for its FM, shortwave, and military VLF transmitters, Continental is most significant historically for its line of mediumwave transmitters, many of which are still in active service as either main transmitters or backup facilities.
Usually used as an ATV repeater output. VSB filters must be used on this channel to keep the signal inside the ham band. Channels 58 and 59 are often offset in frequency to limit interference to the weak-signal and amateur radio satellite sub-bands (431–433 & 435–438 MHz respectively). Many modern CATV receivers can still lock-on to ...
To avoid interference within the equipment at the station, the two frequencies used need to be separated, and ideally on different 'bands'. An unattended station working in this way is a radio repeater. It re-transmits the same information that it receives. This principle is used by telecommunications satellites and terrestrial mobile radio ...