Search results
Results from the WOW.Com Content Network
The service ceiling is the maximum altitude of an aircraft during normal operations. Specifically, it is the density altitude at which flying in a clean configuration , at the best rate of climb airspeed for that altitude and with all engines operating and producing maximum continuous power, will produce a given rate of climb.
This maximum altitude is known as the service ceiling (top limit line in the diagram), and is often quoted for aircraft performance. The area where the altitude for a given speed can no longer be increased at level flight is known as zero rate of climb and is caused by the lift of the aircraft getting smaller at higher altitudes, until it no ...
Coffin corner (also known as the aerodynamic ceiling [1] or Q corner) is the region of flight where a fast but subsonic fixed-wing aircraft's stall speed is near the critical Mach number, at a given gross weight and G-force loading. In this region of flight, it is very difficult to keep an airplane in stable flight.
This occurs at the speed where the difference between engine power and the power required to overcome the aircraft's drag is greatest (maximum excess power). [3] V x increases with altitude and V Y decreases with altitude until they converge at the airplane's absolute ceiling, the altitude above which the airplane cannot climb in steady flight.
The rate of change of aircraft mass with distance is = =, where is the speed), so that = It follows that the range is obtained from the definite integral below, with t 1 {\displaystyle t_{1}} and t 2 {\displaystyle t_{2}} the start and finish times respectively and W 1 {\displaystyle W_{1}} and W 2 {\displaystyle W_{2}} the initial and final ...
The minimum speed that the aircraft is still controllable with the critical engine inoperative [21] while the aircraft is on the ground. V MCL: Minimum control speed in the landing configuration with one engine inoperative. [9] [21] V MO: Maximum operating limit speed. [7] [8] [9] Exceeding V MO may trigger an overspeed alarm. [22] V MU ...
V X increases with altitude, and V Y decreases with altitude until they converge at the airplane's absolute ceiling. Best angle of climb (BAOC) airspeed for an airplane is the speed at which the maximum excess thrust is available. Excess thrust is the difference between the total drag of the aircraft, and the thrust output of the powerplant ...
Finally, an aircraft may be supervised from the ground using surveillance information from e.g. radar or multilateration. ATC can then feed back information to the pilot to help establish position, or can actually tell the pilot the position of the aircraft, depending on the level of ATC service the pilot is receiving.