Search results
Results from the WOW.Com Content Network
In fluid measurement, the fluid's flow conditions (or flowing conditions) refer to quantities like temperature and static pressure of the metered substance.The flowing conditions are required data in order to calculate the density of the fluid at flowing conditions.
Density (volumetric mass density or specific mass) is a substance's mass per unit of volume.The symbol most often used for density is ρ (the lower case Greek letter rho), although the Latin letter D can also be used.
A stratified fluid may be defined as the fluid with density variations in the vertical direction. For example, air and water; both are fluids and if we consider them together then they can be seen as a stratified fluid system. Density variations in the atmosphere profoundly affect the motion of water and air.
The principle of corresponding states (CS principle or CSP) was first formulated by van der Waals, and it says that two fluids (subscript a and z) of a group (e.g. fluids of non-polar molecules) have approximately the same reduced molar volume (or reduced compressibility factor) when compared at the same reduced temperature and reduced pressure ...
μ is the dynamic viscosity of the fluid (Pa·s = N·s/m 2 = kg/m·s) ρ is the density of the fluid (kg/m 3) Pe is the Peclet Number; Re is the Reynolds Number. The heat transfer analog of the Schmidt number is the Prandtl number (Pr). The ratio of thermal diffusivity to mass diffusivity is the Lewis number (Le).
The hydrometer sinks deeper in low-density liquids such as kerosene, gasoline, and alcohol, and less deep in high-density liquids such as brine, milk, and acids. It is usual for hydrometers to be used with dense liquids to have the mark 1.000 (for water) near the top of the stem, and those for use with lighter liquids to have 1.000 near the bottom.
A random mixture can be obtained if two different free-flowing powders of approximately the same particle size, density and shape are mixed (see figure A). [3] Only primary particles are present in this type of mixture, i.e., the particles are not cohesive and do not cling to one another. The mixing time will determine the quality of the random ...
Near 0 °Bé would be approximately the density of water. −100 °Bé (specific gravity, 0.615) would be among the lightest fluids known, such as liquid butane. Thus, the system could be understood as representing a practical spectrum of the density of liquids between −100 and 100, with values near 0 being the approximate density of water.