enow.com Web Search

  1. Ads

    related to: 4 ohm subwoofer wiring

Search results

  1. Results from the WOW.Com Content Network
  2. Bridged and paralleled amplifiers - Wikipedia

    en.wikipedia.org/wiki/Bridged_and_paralleled...

    For example, if two identical amplifiers (each rated for operation into 4 ohm) are paralleled into a 4 ohm load, each amplifier sees an equivalent of 8 ohm since the output current is now shared by both amplifiers — each amplifier supplies half the load current, and the dissipation per amplifier is halved.

  3. Speaker wire - Wikipedia

    en.wikipedia.org/wiki/Speaker_wire

    [citation needed] High-power in-car audio systems using 2-ohm speaker circuits require thicker wire than 4 to 8-ohm home audio applications. Most consumer applications use two conductor wire. A common rule of thumb is that the resistance of the speaker wire should not exceed 5 percent of the rated impedance of the system.

  4. Speakon connector - Wikipedia

    en.wikipedia.org/wiki/Speakon_connector

    Speakon panel connectors (center) provided on a professional PA power amplifier by QSC with a power output of 2 x 700 Watt (4 Ohm) The Speakon (stylized speakON) is a trademarked name for an electrical connector, [2] originally manufactured by Neutrik, mostly used in professional audio systems for connecting loudspeakers to amplifiers.

  5. Linn Isobarik - Wikipedia

    en.wikipedia.org/wiki/Linn_Isobarik

    This 2-way, 4-ohm, design was a physically much smaller product – measuring 425 × 332 × 244 mm (16.7 × 13.1 × 9.6 in) – that required tall speaker stands. Launched in 1978, it was Linn's entry-level loudspeaker until the Kan (a non-isobaric bookshelf speaker using the same Linn D20-LP-1 and KEF B110 drive units as its big brother) was ...

  6. Subwoofer - Wikipedia

    en.wikipedia.org/wiki/Subwoofer

    From about 1900 to the 1950s, the "lowest frequency in practical use" in recordings, broadcasting and music playback was 100 Hz. [9] When sound was developed for motion pictures, the basic RCA sound system was a single 8-inch (20 cm) speaker mounted in straight horn, an approach which was deemed unsatisfactory by Hollywood decisionmakers, who hired Western Electric engineers to develop a ...

  7. Constant-voltage speaker system - Wikipedia

    en.wikipedia.org/wiki/Constant-voltage_speaker...

    Constant-voltage speaker systems are also commonly referred to as 25-, 70-, 70.7-, 100 or 210-volt speaker systems; distributed speaker systems; or high-impedance speaker systems. In Canada and the US, they are most commonly referred to as 70-volt speakers. In Europe, the 100 V system is the most widespread, with amplifier and speaker products ...

  1. Ads

    related to: 4 ohm subwoofer wiring