enow.com Web Search

  1. Ads

    related to: 12 v aftermarket fuel sending unit 0 90 ohms

Search results

  1. Results from the WOW.Com Content Network
  2. MegaSquirt - Wikipedia

    en.wikipedia.org/wiki/MegaSquirt

    MegaSquirt is a general-purpose aftermarket electronic fuel injection (EFI) controller designed to be used with a wide range of spark-ignition internal combustion engines (i.e., non-diesel engines.) MegaSquirt was designed by Bruce Bowling and Al Grippo in 2001.

  3. Voltage regulation - Wikipedia

    en.wikipedia.org/wiki/Voltage_regulation

    In the voltage regulation formula, V no load is the voltage measured at the receiving end terminals when the receiving end is an open circuit. The entire short line model is an open circuit in this condition, and no current flows in an open circuit, so I = 0 A and the voltage drop across the line given by Ohm’s law V line drop = IZ line is 0 ...

  4. Continental AV1790 - Wikipedia

    en.wikipedia.org/wiki/Continental_AV1790

    Restored Continental AV1790-5B tank engine at the American Armored Foundation Tank Museum in Danville, Virginia. The Continental AV1790 is an American V12 engine used in armored vehicles.

  5. Detroit Diesel Series 149 - Wikipedia

    en.wikipedia.org/wiki/Detroit_Diesel_Series_149

    The first number indicates the number of cylinders per engine, the "V" indicates a V-type cylinder arrangement, and the last set of numbers indicates the series of the engine. Suffixes are commonplace with Detroit Diesel model designations: "T" means the engine is equipped with turbochargers, "I" for intercoolers, and "B" for by-pass Roots-type ...

  6. Fuel gauge - Wikipedia

    en.wikipedia.org/wiki/Fuel_gauge

    Magnetoresistance type fuel level sensors, now becoming common in small aircraft applications, offer a potential alternative for automotive use.These fuel level sensors work similar to the potentiometer example, however a sealed detector at the float pivot determines the angular position of a magnet pair at the pivot end of the float arm.

  7. Phantom power - Wikipedia

    en.wikipedia.org/wiki/Phantom_Power

    The signal conductors are positive, both fed through resistors of equal value (6.81 kΩ for 48 V, 1.2 kΩ for 24 V, and 680 Ω for 12 V), and the shield is ground. The 6.81 kΩ value is not critical, but the resistors must be matched to within 0.1% [ 6 ] or better to maintain good common-mode rejection in the circuit.

  1. Ads

    related to: 12 v aftermarket fuel sending unit 0 90 ohms