Ads
related to: automotive engine run stand manual throttle controlwalmart.com has been visited by 1M+ users in the past month
assistantking.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
Accelerate-by-wire or throttle-by-wire, [17] more commonly known as electronic throttle control, is a system that actuates vehicle propulsion without any mechanical connections, such as cables, from the accelerator pedal to the throttle valve of the engine or other propulsion systems. In electric vehicles, this system controls the electric ...
The IAC allows the ECU to maintain minimum RPM irrespective of changes in engine load, sometimes referred to as anti-stall feature. Thus the driver can more easily move the car from stand-still by merely releasing the clutch (manual transmission) or the brake (automatic transmission) without having to simultaneously press the accelerator.
Some engine control units (ECUs) also control the throttle position by electronic throttle control (ETC) or "drive by wire" systems, and if that is done, the position sensor is used in a feedback loop to enable that control. [1] Related to the TPS are accelerator pedal sensors, which often include a wide open throttle (WOT) sensor.
Electronic controllers add greater flexibility in management of boost pressures, compared with the manual controllers. [2] The actuation of an electronic boost controller can be managed by one of two control systems: Open-loop is the simpler option, where control output is merely based on other inputs such as throttle angle and/or engine speed ...
The Ford EEC (Electronic Engine Control) system, which utilized the Toshiba TLCS-12 microprocessor, went into mass production in 1975. [ 7 ] The first Bosch engine management system was the Motronic 1.0 , which was introduced in the 1979 BMW 7 Series (E23) [ 8 ] This system was based on the existing Bosch Jetronic fuel injection system, to ...
Ads
related to: automotive engine run stand manual throttle controlwalmart.com has been visited by 1M+ users in the past month
assistantking.com has been visited by 10K+ users in the past month