Search results
Results from the WOW.Com Content Network
An analog-to-digital converter (ADC) performs the reverse function. There are several DAC architectures; the suitability of a DAC for a particular application is determined by figures of merit including: resolution, maximum sampling frequency and others. Digital-to-analog conversion can degrade a signal, so a DAC should be specified that has ...
Flash converters are high-speed compared to many other ADCs, which usually narrow in on the correct answer over a series of stages. Compared to these, a flash converter is also quite simple and, apart from the analog comparators, only requires logic for the final conversion to binary .
Each tap of the string generates a different voltage, which can be compared with another voltage: this is the basic principle of a flash ADC (analog-to-digital converter). The main disadvantage is that this architecture requires 2 n {\displaystyle 2^{n}} comparators, one for each resistor; and this number cannot be reduced by using an R-2R ...
4-channel stereo multiplexed analog-to-digital converter WM8775SEDS made by Wolfson Microelectronics placed on an X-Fi Fatal1ty Pro sound card AD570 8-bit successive-approximation analog-to-digital converter AD570/AD571 silicon die INTERSIL ICL7107. 3.5 digit (i.e. conversion from analog to a numeric range of 0 to 1999 vs. 3 digit range of 0 to 999, typically used in meters, counters, etc ...
A 1-bit DAC (sometimes called Bitstream converter by Philips) is a consumer electronics marketing term describing an oversampling digital-to-analog converter (DAC) that uses a digital noise shaping delta-sigma modulator operating at many multiples of the sampling frequency that outputs to an actual 1-bit DAC (which could be fully differential to minimize crosstalk). [1]
Figure 1 - Direct Digital Synthesizer block diagram. A basic Direct Digital Synthesizer consists of a frequency reference (often a crystal or SAW oscillator), a numerically controlled oscillator (NCO) and a digital-to-analog converter (DAC) [5] as shown in Figure 1.
Delta-sigma (ΔΣ; or sigma-delta, ΣΔ) modulation is an oversampling method for encoding signals into low bit depth digital signals at a very high sample-frequency as part of the process of delta-sigma analog-to-digital converters (ADCs) and digital-to-analog converters (DACs).
The zero-order hold (ZOH) is a mathematical model of the practical signal reconstruction done by a conventional digital-to-analog converter (DAC). [1] That is, it describes the effect of converting a discrete-time signal to a continuous-time signal by holding each sample value for one sample interval. It has several applications in electrical ...