Search results
Results from the WOW.Com Content Network
An address bus is a bus that is used to specify a physical address. When a processor or DMA-enabled device needs to read or write to a memory location, it specifies that memory location on the address bus (the value to be read or written is sent on the data bus). The width of the address bus determines the amount of memory a system can address.
A system bus is a single computer bus that connects the major components of a computer system, combining the functions of a data bus to carry information, an address bus to determine where it should be sent or read from, and a control bus to determine its operation. The technique was developed to reduce costs and improve modularity, and ...
Diagram of relationship between the virtual and physical address spaces. In computing, a physical address (also real address, or binary address), is a memory address that is represented in the form of a binary number on the address bus circuitry in order to enable the data bus to access a particular storage cell of main memory, or a register of memory-mapped I/O device.
The efficiency of addressing of memory depends on the bit size of the bus used for addresses – the more bits used, the more addresses are available to the computer. For example, an 8-bit-byte-addressable machine with a 20-bit address bus (e.g. Intel 8086) can address 2 20 (1,048,576) memory locations, or one MiB of memory, while a 32-bit bus ...
In computer architecture, a control bus is part of the system bus and is used by CPUs for communicating with other devices within the computer. While the address bus carries the information about the device with which the CPU is communicating and the data bus carries the actual data being processed, the control bus carries commands from the CPU and returns status signals from the devices.
The MAR register is half of a minimal interface between a microprogram and computer storage; the other half is a MDR. In general, MAR is a parallel load register that contains the next memory address to be manipulated, for example the next address to be read or written.
For example, in a computer, address information is transmitted synchronously—the address bits over the address bus, and the read or write strobes of the control bus. Single-wire synchronous signalling. A logical one is indicated when there are two transitions in the same time frame as a zero.
APB is designed for low bandwidth control accesses, for example register interfaces on system peripherals. This bus has an address and data phase similar to AHB, but a much reduced, low complexity signal list (for example no bursts). Furthermore, it is an interface designed for a low frequency system with a low bit width (32 bits).