Search results
Results from the WOW.Com Content Network
An ATX power supply provides a number of peripheral power connectors and (in modern systems) two connectors for the motherboard: an 8-pin (or 4+4-pin) auxiliary connector providing additional power to the CPU and a main 24-pin power supply connector, an extension of the original 20-pin version. 20-pin Molex 39-29-9202 at the motherboard. 20-pin ...
Entry-Level Power Supply Specification (EPS) is a power supply unit meant for high-power-consumption computers and entry-level servers. Developed by the Server System Infrastructure (SSI) forum, a group of companies including Intel, Dell, Hewlett-Packard and others, that works on server standards, the EPS form factor is a derivative of the ATX ...
Derived from the EEB and ATX specifications. microATX: Intel: 1996 244 × 244 mm (9.6 × 9.6 in) A 20 % shorter variant of the ATX form factor. Compatible with most ATX cases, but has fewer slots than ATX, for a smaller power supply unit. Very popular for desktop and small form factor computers as of 2017. Mini-ATX: AOpen: 2005
The ATX specification requires that the power-good signal ("PWR_OK") go high no sooner than 100 ms after the power rails have stabilized, and remain high for 16 ms after loss of AC power, and fall (to less than 0.4 V) at least 1 ms before the power rails fall out of specification (to 95% of their nominal value).
English: Pinouts of ATX power supply connectors, displayed according to Intel's Power Supply Design Guide for Desktop Platform Form Factors v1.2 (2008) and v1.31 (2013) COM = COMMON VSB = Volts Stand-By
Officially, the NLX form factor was designed to use ATX power supplies and featured the same soft power function. However, for size reduction, some NLX cases instead used the smaller SFX form factor or proprietary form factors with the same 20-pin connector.
FlexATX is a motherboard form factor derived from ATX.The specification was released in 1999 by Intel as an addendum to the microATX specification. It uses a subset of the motherboard mounting holes required for microATX and the same I/O plate system as ATX and microATX.
The power connector on the 3½-inch floppy drive, informally known as "the Berg connector", is 2.50 mm pitch (distance from center to center of pins). The power cable from the ATX power supply consists of 20 AWG wire to a 4-pin female connector. [ 1 ]