Search results
Results from the WOW.Com Content Network
Thermoelectric cooling uses the Peltier effect to create a heat flux at the junction of two different types of materials. A Peltier cooler, heater, or thermoelectric heat pump is a solid-state active heat pump which transfers heat from one side of the device to the other, with consumption of electrical energy, depending on the direction of the current.
The Peltier effect can be considered as the back-action counterpart to the Seebeck effect (analogous to the back-EMF in magnetic induction): if a simple thermoelectric circuit is closed, then the Seebeck effect will drive a current, which in turn (by the Peltier effect) will always transfer heat from the hot to the cold junction.
This page was last edited on 23 May 2009, at 11:13 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply ...
The typical efficiency of TEGs is around 5–8%, although it can be higher. Older devices used bimetallic junctions and were bulky. More recent devices use highly doped semiconductors made from bismuth telluride (Bi 2 Te 3), lead telluride (PbTe), [10] calcium manganese oxide (Ca 2 Mn 3 O 8), [11] [12] or combinations thereof, [13] depending on application temperature.
The Peltier effect is the presence of heating or cooling at an electrified junction of two different conductors (1834). [7] His great experimental discovery was the heating or cooling of the junctions in a heterogeneous circuit of metals according to the direction in which an electric current is made to pass round the circuit.
Science (Physics, Biology) — Yes — link: CIE 5126 Science (Chemistry, Biology) — Yes — link: CIE 5129 Combined Science: Yes Yes Yes Cannot be combined with syllabuses 0608, 0610, 0620, 0625, 0652, 0653 & 0654 , 5054, 5070, 5090, 5096 & 5131 (O Level) link: CIE 5130 Additional Combined Science: No Yes Yes last exam in 2007 link: CIE 5131 ...
The Seebeck coefficient (also known as thermopower, [1] thermoelectric power, and thermoelectric sensitivity) of a material is a measure of the magnitude of an induced thermoelectric voltage in response to a temperature difference across that material, as induced by the Seebeck effect. [2]
There are two types of continuous cooling diagrams drawn for practical purposes. Type 1: This is the plot beginning with the transformation start point, cooling with a specific transformation fraction and ending with a transformation finish temperature for all products against transformation time for each cooling curve.