enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Homasote - Wikipedia

   en.wikipedia.org/wiki/Homasote

   It is available in multiple thicknesses and comes in sheets 4 by 8 feet (1.2 by 2.4 m). [ 2 ] [ 3 ] The Homasote Company operates a 750,000-square-foot (70,000 m 2 ) factory in the West Trenton section of Ewing Township, New Jersey .

3. Hardboard - Wikipedia

   en.wikipedia.org/wiki/Hardboard

   Hardboard is similar to particle board and medium-density fiberboard, but is denser, stronger and harder because it is made out of exploded wood fibers that have been highly compressed. [ 3 ] The density of hardboard is higher than 500 kg/m 3 (31 lb/cu ft), [ 4 ] usually about 800–1,040 kg/m 3 (50–65 lb/cu ft). [ 5 ]

4. Cement board - Wikipedia

   en.wikipedia.org/wiki/Cement_board

   This 5 ⁄ 16 inch (7.9 mm) thick cement board is designed as an underlayment for tile floors. These are 3-by-5-foot (91 by 152 cm) sheets. These are 3-by-5-foot (91 by 152 cm) sheets. A cement board is a combination of cement and reinforcing fibers formed into sheets, of varying thickness that are typically used as a tile backing board. [ 1 ]

5. Shiplap - Wikipedia

   en.wikipedia.org/wiki/Shiplap

   Shiplap is either rough-sawn 25 mm (1 in) or milled 19 mm (3 ⁄ 4 in) pine or similarly inexpensive wood between 76 and 254 mm (3 and 10 in) wide with a 9.5–12.7 mm (3 ⁄ 8 – 1 ⁄ 2 in) rabbet on opposite sides of each edge. [1] The rabbet allows the boards to overlap in this area. The profile of each board partially overlaps that of the ...

6. Laminate panel - Wikipedia

   en.wikipedia.org/wiki/Laminate_panel

   Laminate panel is a type of manufactured timber made from thin sheets of substrates or wood veneer. It is similar to the more widely used plywood, except that it has a plastic, protective layer on one or both sides. Laminate panels are used instead of plywood because of their resistance to impact, weather, moisture, shattering in cold ...

7. Floor - Wikipedia

   en.wikipedia.org/wiki/Floor

   The two layers in high-quality construction will both be thick 3 ⁄ 4 inch (19.1 mm) sheets (as will the third when present), but they may have a combined thickness of only half that in cheaper construction – 1 ⁄ 2 in (12.7 mm) panel overlaid by 1 ⁄ 4 in (6.4 mm) plywood subflooring. At the highest end, or in select rooms of the building ...