Search results
Results from the WOW.Com Content Network
Larssen sheet piling was developed in 1906 by Tryggve Larssen, engineer from Bremen (Germany). [ 2 ] [ 3 ] [ 4 ] Its applications include piers , oil terminals , waste storage facilities, shoreline protection, [ 5 ] bridges, houses, buildings, dry docks, other construction sites, and for the strengthening of pond banks, preventing slumping into ...
Sheet piles are used to restrain soft soil above the bedrock in this excavation. Sheet piling is a form of driven piling using thin interlocking sheets of steel to obtain a continuous barrier in the ground. The main application of sheet piles is in retaining walls and cofferdams erected to enable permanent works to proceed. Normally, vibrating ...
A steel sheet pile being hydraulically pressed. Hydraulic press-in equipment installs piles using hydraulic rams to press piles into the ground. This system is preferred where vibration is a concern. There are press attachments that can adapt to conventional pile driving rigs to press 2 pairs of sheet piles simultaneously.
Tiebacks are drilled into soil using a small diameter shaft, and usually installed at an angle of 15 to 45 degrees. [2] [1] They can be either drilled directly into a soldier pile, or through a wale installed between consecutive piles. Grouted tiebacks can be constructed as steel rods drilled through a concrete wall out into the soil or bedrock ...
Cofferdams are commonly used for construction or repair of permanent dams, oil platforms, bridge piers, etc., built within water. They also form an integral part of naval architecture. These cofferdams are usually welded steel structures, with components consisting of sheet piles, wales, and cross braces. Such structures are usually dismantled ...
Sheet piles are used to restrain soft soil above the bedrock in this excavation. Sheet piling is a form of driven piling using thin interlocking sheets of steel to obtain a continuous barrier in the ground. The main application of sheet piles is in retaining walls and cofferdams erected to enable permanent works to proceed. Normally, vibrating ...
There are a number of methods for the construction of shafts, the most significant being: The use of sheet piles, diaphragm walls or bored piles to construct a square or rectangular braced shaft; The use of segmental lining installed by underpinning or caisson sunk to form a circular shaft
Excavation may be classified by type of material: [1]: 13.1 Topsoil excavation; Earth excavation; Rock excavation; Muck excavation – this usually contains excess water and unsuitable soil; Unclassified excavation – this is any combination of material types; Excavation may be classified by the purpose: [1]: 13.1, 13.2