Ads
related to: furring strips dimensionsebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
Vertical, metal furring is applied to the wall to create a channel and receive the siding material. In construction, furring (furring strips) are strips of wood or other material applied to a structure to level or raise the surface, to prevent dampness, to make space for insulation, to level and resurface ceilings or walls, [1] or to increase the beam of a wooden ship.
Self-furring lath is an expanded metal lath which is dimpled to hold itself off from a solid surface; Wire lath is made from welded or woven wires and is similar to hardware cloth; Paper backed wire lath is wire lath with building paper attached; Strip laths is metal lath that is several inches wide and is often used to reinforce joints and on ...
Batten trim or batten molding is a thin strip of trim typically with a rectangular cross-section similar to lath used in lattice, used to cover seams between panels of exterior siding or interior paneling.
Lath seen from the back with white plaster coat oozing through. Lath and plaster is a building process used to finish mainly interior dividing walls and ceilings. It consists of narrow strips of wood which are nailed horizontally across the wall studs or ceiling joists and then coated in plaster.
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a
Tin panels today are made in 24-by-24-inch (610 mm × 610 mm) and 24-by-48-inch (610 mm × 1,220 mm) sizes for easier handling and one-person installation. Today, most tin ceiling manufacturers actually use recycled blackplate steel in a thickness of only 0.010 inches (0.25 mm).
The sizes also vary from country to country; in North America shakes are usually made in 24-inch (610 mm) lengths - the most common, 18-inch (460 mm) barn shake, or even 48-inch (1,200 mm) shakes, which are typically used for siding.
Furring strips are applied to the sheathing to create a vented air space between the radiant barrier and the siding, and vents are used at the top and bottom to allow convective heat to rise naturally to the attic. If brick is being used on the exterior, then a vented air space may already be present, and furring strips are not necessary.
Ads
related to: furring strips dimensionsebay.com has been visited by 1M+ users in the past month