Search results
Results from the WOW.Com Content Network
The oil is dyed blue to make it easier to recognize in the gasoline. It appears black in this bottle because it is not diluted. Two-stroke oil (also referred to as two-cycle oil, 2-cycle oil, 2T oil, or 2-stroke oil) is a special type of motor oil intended for use in crankcase compression two-stroke engines, typical of small gasoline-powered ...
[2] Most of the braking power is on the front wheels of a vehicle, which means you will have more effective braking when more weight is over the front wheels. When the rear end has a heavy load, the braking is not as effective. The weight is concentrated on the rear end of the vehicle, and the rear brakes need to do all of the work.
Animation of a two-stroke engine. A two-stroke (or two-stroke cycle) engine is a type of internal combustion engine that completes a power cycle with two strokes of the piston (one up and one down movement) in one revolution of the crankshaft in contrast to a four-stroke engine which requires four strokes of the piston in two crankshaft revolutions to complete a power cycle.
A stroke is the action of a piston travelling the full length of its cylinder.In a two-stroke engine, one of the two strokes combines primarily the intake stroke and the combustion stroke, while the other stroke primarily combines the compression stroke and the exhaust stroke, though technically since both ports are exposed during both the combustion and compression strokes, some reversion ...
Data from Cliche & HKS General characteristics Type: Two cylinder, four-stroke aircraft engine Bore: 85 mm (3.3 in) Stroke: 60 mm (2.4 in) Displacement: 680 cc (41.49 cu in) Dry weight: 55 kg (121 lb) equipped with electrical system, electric starter, carburetors, gearbox, exhaust system, oil tank and cooler Components Valvetrain: two intake and two exhaust valves per cylinder Fuel type ...
A stratified charge can allow for slightly higher compression ratios without "knock," and leaner air/fuel ratio than in conventional internal combustion engines. Conventionally, a four-stroke (petrol or gasoline) Otto cycle engine is fueled by drawing a mixture of air and fuel into the combustion chamber during the intake stroke
The 225 used the RG (tall) block with a 3 + 2 ⁄ 5 in (86.4 mm) bore, a 4 + 1 ⁄ 8 in (104.8 mm) stroke and 6.699 in (170.2 mm) connecting rods, for an actual displacement of 224.7 cu in (3.7 L). This undersquare geometry was a departure from the emerging trend towards oversquare engines.
For example, if the static compression ratio is 10:1, and the dynamic compression ratio is 7.5:1, a useful value for cylinder pressure would be 7.5 1.3 × atmospheric pressure, or 13.7 bar (relative to atmospheric pressure). The two corrections for dynamic compression ratio affect cylinder pressure in opposite directions, but not in equal strength.