Search results
Results from the WOW.Com Content Network
To set up a live USB system for commodity PC hardware, the following steps must be taken: A USB flash drive needs to be connected to the system, and be detected by it; One or more partitions may need to be created on the USB flash drive; The "bootable" flag must be set on the primary partition on the USB flash drive
Windows Mobile supports accessing most USB mass-storage devices formatted with FAT on devices with USB Host. However, portable devices typically cannot provide enough power for hard-drive disk enclosures (a 2.5-inch (64 mm) hard drive typically requires the maximum 2.5 W in the USB specification) without a self-powered USB hub. A Windows Mobile ...
Early BIOS versions did not have passwords or boot-device selection options. The BIOS was hard-coded to boot from the first floppy drive, or, if that failed, the first hard disk. Access control in early AT-class machines was by a physical keylock switch (which was not hard to defeat if the computer case could be opened).
OS boot loaders can be automatically detected by UEFI, which enables easy booting from removable devices such as USB flash drives. This automated detection relies on standardized file paths to the OS boot loader, with the path varying depending on the computer architecture .
It is intended to replace MS-DOS boot disks and can be booted via USB flash drive, PXE, iPXE, [1] CD, DVD, or hard drive. Traditionally used by large corporations and OEMs (to preinstall Windows client operating systems on PCs during manufacturing), it is now widely available free of charge via Windows Assessment and Deployment Kit (WADK ...
Sleep-and-charge USB ports can be used to charge electronic devices even when the computer that hosts the ports is switched off. Normally, when a computer is powered off the USB ports are powered down. This feature has also been implemented on some laptop docking stations allowing device charging even when no laptop is present. [82]
On system with BIOS firmware, the BIOS invokes MBR boot code from a hard disk drive at startup. The MBR boot code and the VBR boot code are OS-specific. In Microsoft Windows, the MBR boot code tries to find an active partition (the MBR is only 512 bytes), then executes the VBR boot code of an active partition. The VBR boot code tries to find ...
The partition type (or partition ID) in a partition's entry in the partition table inside a master boot record (MBR) is a byte value intended to specify the file system the partition contains or to flag special access methods used to access these partitions (e.g. special CHS mappings, LBA access, logical mapped geometries, special driver access, hidden partitions, secured or encrypted file ...