enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. GM 10.5-inch 14-bolt differential - Wikipedia

   en.wikipedia.org/wiki/GM_10.5-inch_14-bolt...

   Identification between the two can be made by examining the hub: the protrusion of the hub through the center of the wheel denotes the preferred 10.5-inch full-floating rear axle. While the 9.5-inch rear end exhibits its own durability, it is generally considered less favorable for high-torque applications.

3. Wheel hub assembly - Wikipedia

   en.wikipedia.org/wiki/Wheel_hub_assembly

   The hub assembly is located between the brake drums or discs and the drive axle. A wheel is bolted on it. Depending on the construction, the end of the hub comes equipped with the splined teeth. They mate the teeth on the axle shaft. The axle hub spins along with the wheels bolted to it and provide power to the wheels in order to rotate.

4. Steering knuckle - Wikipedia

   en.wikipedia.org/wiki/Steering_knuckle

   The wheel and tire assembly attach to the hub or spindle of the knuckle where the tire/wheel rotates while being held in a stable plane of motion by the knuckle/suspension assembly. In the attached photograph of a double-wishbone suspension, the knuckle is shown attached to the upper control arm at the top and the lower control arm at the bottom.

5. Hub-center steering - Wikipedia

   en.wikipedia.org/wiki/Hub-center_steering

   Hub-center steering systems use an arm, or arms, on bearings to allow upward wheel deflection, meaning that there is no stiction, even under braking. Braking forces can be redirected horizontally along these arms, or tie rods, away from the vertical suspension forces, and can even be put to good use to counteract weight transfer .

6. Sturmey-Archer - Wikipedia

   en.wikipedia.org/wiki/Sturmey-Archer

   All Sturmey-Archer gear hubs use epicyclic (planetary) geartrains of varying complexity. The AW is the simplest, using one set of planetary gears with four planets. The AM uses three compound planets with differently sized cogs machined from a common shaft to engage the gear ring and sun gear separately, while the close-ratio three-speeds, and hubs with four or more speeds, use multiple ...

7. Cogset - Wikipedia

   en.wikipedia.org/wiki/Cogset

   A freewheel and freewheel hub A freehub (above) for use with a cassette and a threaded hub (below) for use with a freewheel. A freewheel (also known as a block) consists of either a single sprocket or a set of sprockets mounted on a body which contains an internal ratcheting mechanism and mounts on a threaded hub. Threaded rear hubs were ...