Search results
Results from the WOW.Com Content Network
A bias tee is a three-port network used for setting the DC bias point of some electronic components without disturbing other components. The bias tee is a diplexer.The low-frequency port is used to set the bias; the high-frequency port passes the radio-frequency signals but blocks the biasing levels; the combined port connects to the device, which sees both the bias and RF.
Cartridge adapters have also been made to use .38 caliber handgun cartridges with bullet diameters of approximately .357-inch (9.1 mm) in .35 caliber rifles designed for bullets of .358-inch (9.1 mm) diameter. [3] Supplemental chambers in .22 caliber, and potentially .17 caliber as well, pose a special problem not shared by larger calibers.
The beam confining plates are the silver coloured structures to the left and right Comparison of anode characteristic of beam power tube and power pentode Twin beam tetrode RCA-815, used as the bias oscillator tube in the Ampex Model 300 "bathtub" 1/4" full-track professional audio tape recorder Internal Construction of 4CX250B radial beam ...
A graphical representation of the current and voltage properties of a transistor; the bias is selected so that the operating point permits maximum signal amplitude without distortion. In electronics , biasing is the setting of DC ( direct current ) operating conditions (current and voltage) of an electronic component that processes time-varying ...
a fitting that connects pipes of different diameters, genders, or threads (see § Coupling below) [10] adapter spools (also called crossover spools), used on oilfields and pressure control, have different diameters, pressure ratings or designs at each end [11] adapters to convert NPT to BSP pipe threads are available [12]
In electronics, cathode bias (also known as self-bias, or automatic bias) is a technique used with vacuum tubes to make the direct current (dc) cathode voltage positive in relation to the negative side of the plate voltage supply by an amount equal to the magnitude of the desired grid bias voltage.
Adapters (sometimes called dongles) allow connecting a peripheral device with one plug to a different jack on the computer. They are often used to connect modern devices to a legacy port on an old system, or legacy devices to a modern port. Such adapters may be entirely passive, or contain active circuitry. A common type is a USB adapter.
Plate detector circuit with cathode bias. Cathode bias RC time constant three times period of lowest carrier frequency. C L is typically around 250 pF.. In electronics, a plate detector (anode bend detector, grid bias detector) is a vacuum tube circuit in which an amplifying tube having a control grid is operated in a non-linear region of its grid voltage versus plate current transfer ...