Search results
Results from the WOW.Com Content Network
No. 5 fuel oil is also called Navy Special Fuel Oil (NSFO) or just navy special; No. 5 or 6 are also commonly called heavy fuel oil (HFO) or furnace fuel oil (FFO); the high viscosity requires heating, usually by a recirculated low pressure steam system, before the oil can be pumped from a bunker tank. Bunkers are rarely labeled this way in ...
[3] [4] Its primary fuel was Diesel #1, #2, or AP, but 70% to 90% of other fuels could be mixed with diesel, depending on how smooth the engine would run. Low octane commercial and aviation gasoline could be used if engine oil was added, jet fuel Jet A, B, JP-4, 5, 7, and 8 could be used, as well as fuel oil #1 and #2. [5]
Fuel additives in the United States are regulated under section 211 of the Clean Air Act (as amended in January 1995). The Environmental Protection Agency (EPA) requires the registration of all fuel additives which are commercially distributed for use in highway motor vehicles in the United States, [8] and may require testing and ban harmful additives.
The largest share of oil products is used as "energy carriers", i.e. various grades of fuel oil and gasoline. These fuels include or can be blended to give gasoline, jet fuel, diesel fuel, heating oil, and heavier fuel oils. Heavier (less volatile) fractions can also be used to produce asphalt, tar, paraffin wax, lubricating and
An improved flex-fuel engine generation was developed to eliminate the need for the secondary gas tank by warming the ethanol fuel during starting, [156] [157] and allowing them to start at temperatures as low as −5 °C (23 °F), [158] the lowest temperature expected anywhere in the Brazilian territory. [159]
The International Lubricant Standardization and Approval Committee (ILSAC) also has standards for motor oil. Introduced in 2004, GF-4 [27] applies to SAE 0W-20, 5W-20, 0W-30, 5W-30, and 10W-30 viscosity grade oils. In general, ILSAC works with API in creating the newest gasoline oil specification, with ILSAC adding an extra requirement of fuel ...
Gas blending is the process of mixing gases for a specific purpose where the composition of the resulting mixture is defined, and therefore, controlled. A wide range ...
Emulsified fuels are a type of emulsion that combines water with a combustible liquid, such as oil or fuel. An emulsion is a specialized form of dispersion that contains both a continuous phase and a dispersed phase. The most commonly utilized emulsified fuel is a water-in-diesel emulsion (also known as hydrodiesel). [1]