Search results
Results from the WOW.Com Content Network
An important parameter in wet scrubbing systems is the rate of liquid flow. It is common in wet scrubber terminology to express the liquid flow as a function of the gas flow rate that is being treated. This is commonly called the liquid-to-gas ratio (L/G ratio) and uses the units of gallons per 1,000 actual cubic feet or litres per cubic metre ...
According to Primus Green Energy, the STG+ process converts natural gas into 90+-octane gasoline at approximately 5 US gallons per million British thermal units (65 litres per megawatt-hour). [4] The energy content of gasoline is 120,000 to 125,000 British thermal units per US gallon (9.3 to 9.7 kilowatt-hours per litre), making this process ...
The gas–liquid separation section of the separator is determined by the maximum removal droplet size using the Souders–Brown equation with an appropriate K factor. The oil-water separation section is held for a retention time that is provided by laboratory test data, pilot plant operating procedure, or operating experience.
The fuel consumption is an equivalent measure for cars sold outside the United States, typically measured in litres per 100 km traveled; in general, the fuel consumption and miles per gallon would be reciprocals with appropriate conversion factors, but because different countries use different driving cycles to measure fuel consumption, fuel ...
Gas to liquids (GTL) is a refinery process to convert natural gas or other gaseous hydrocarbons into longer-chain hydrocarbons, such as gasoline or diesel fuel. Methane -rich gases are converted into liquid synthetic fuels .
Gas/liquid separation takes place in these pipes with the liquid dropping to the bottom of the pipes with the gas above. Liquid-free gas is drawn off at the far end of the separation pipes by risers at the top of the pipes. The risers are manifolded together and the gas is routed to further treatment. From the base of the separation pipes ...
Liquefaction of gases is physical conversion of a gas into a liquid state (condensation). The liquefaction of gases is a complicated process that uses various compressions and expansions to achieve high pressures and very low temperatures, using, for example, turboexpanders .
Vertical separators are generally used when the gas-liquid ratio is high or gas volumes are high. Horizontal separators are used where large volumes of liquid are involved. [5] A vapor-liquid separator may operate as a 3-phase separator, with two immiscible liquid phases of different densities. For example natural gas (vapor), water and oil ...