Search results
Results from the WOW.Com Content Network
To allow the construction of hybrid systems, where the 4–20 mA is generated by the controller, but allows the use of pneumatic valves, a range of current to pressure (I to P) converters are available from manufacturers. These are usually local to the control valve and convert 4–20 mA to 3–15 psi (or 0.2–1.0 bar).
A typical kitchen timer. A timer or countdown timer is a type of clock that starts from a specified time duration and stops upon reaching 00:00. An example of a simple timer is an hourglass. Commonly, a timer triggers an alarm when it ends. A timer can be implemented through hardware or software.
A 20×4-character display. In 8-bit mode, all transfers happen in one cycle of the enable pin (E) with all 8 bits on the data bus and the RS and R/ W pins stable. In 4-bit mode, data are transferred as pairs of 4-bit "nibbles" on the upper data pins, D7–D4, with two enable pulses and the RS and R/ W pins stable. The four most significant bits ...
Clock signal and legend. In electronics and especially synchronous digital circuits, a clock signal (historically also known as logic beat) [1] is an electronic logic signal (voltage or current) which oscillates between a high and a low state at a constant frequency and is used like a metronome to synchronize actions of digital circuits.
The Intel 8253 PIT was the original timing device used on IBM PC compatibles.It used a 1.193182 MHz clock signal (one third of the color burst frequency used by NTSC, one twelfth of the system clock crystal oscillator, [1] therefore one quarter of the 4.77 MHz CPU clock) and contains three timers.
A time switch (also called a timer switch, or simply timer) is a device that operates an electric switch controlled by a timer. Intermatic introduced its first time switch in 1945, which was used for "electric signs, store window lighting, apartment hall lights, stokers, and oil and gas burners." A consumer version was added in 1952.
The counter implementation's accuracy is limited by the clock frequency. If time is measured by whole counts, then the resolution is limited to the clock period. For example, a 10 MHz clock has a resolution of 100 ns. To get resolution finer than a clock period, there are time interpolation circuits. [6]
The on-time marker is the leading edge of the first start bit. IRIG J-1 timecode consists of 15 characters (150 bit times), sent once per second at a baud rate of 300 or greater: <SOH>DDD:HH:MM:SS<CR><LF>