Search results
Results from the WOW.Com Content Network
Once the appropriate connector has been identified, the termination process can begin. Common termination methods include no-epoxy-no-polish, epoxy and polish and pigtail splicing. [2] Regardless of the method, the beginning steps are the same. First, the sleeve, or secondary coating, must be stripped from the fiber. The primary coating must ...
A pigtail is similar to a patch cord and is the informal name given to a cable fitted with a connector at one end and bare wires (or bare fibre) at the other. In the context of copper cabling, these cables are sometimes referred to as blunt patch cords and the non-connectorized end ("the pigtail") is intended to be permanently attached to a ...
Building wiring, wall outlets LC: Lucent Connector, [9] Little Connector, [14] or Local Connector [14] Latch — 1.25 mm IEC 61754-20 [8] High-density connections, SFP and SFP+ transceivers, XFP transceivers. [11] Duplex LC is comparable in size to RJ-45. [C] Luxcis 1.25 mm ARINC 801 PC (straight physical contact) or APC (angled physical ...
An automotive wiring diagram, showing useful information such as crimp connection locations and wire colors. These details may not be so easily found on a more schematic drawing. A wiring diagram is a simplified conventional pictorial representation of an electrical circuit. It shows the components of the circuit as simplified shapes, and the ...
When a generic power outlet was desired, the wiring could run directly into the junction box through a tube of protective loom and a ceramic bushing. Wiring devices such as light switches, receptacle outlets, and lamp sockets were either surface-mounted, suspended, or flush-mounted within walls and ceilings.
Less commonly, a terminator is also placed at the driving end of the wire or cable, if not already part of the signal-generating equipment. [ 1 ] Radio frequency currents tend to reflect from discontinuities in the cable, such as connectors and joints, and travel back down the cable toward the source, causing interference as primary reflections.
However, the manufacturer's instructions for the Ideal no. 65 Twister [19] only recommends pre-twisting the wires, and does not state it is required. Also, the instructions do not mention physically abrading the wires as recommended by the CPSC, although the manufacturer current literature states the pre-filled "compound cuts aluminum oxide".
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.