Search results
Results from the WOW.Com Content Network
Margins also play an important role in digital word-processing and can be changed using the page setup menu. The default margins for Microsoft Word from version 2007 onward have been 1 inch (25.4 mm) all around; in Word 2003, the default top and bottom margins were 1 inch (25.4 mm), but 1.25 inches (31.7 mm) were given at the left and the right.
The traditional typographic units are based either on non-metric units, or on odd multiples (such as 35 ⁄ 83) of a metric unit.There are no specifically metric units for this particular purpose, although there is a DIN standard sometimes used in German publishing, which measures type sizes in multiples of 0.25 mm, and proponents of the metrication of typography generally recommend the use of ...
The pica is a typographic unit of measure corresponding to approximately 1 ⁄ 6 of an inch, or from 1 ⁄ 68 to 1 ⁄ 73 of a foot. One pica is further divided into 12 points. In printing, three pica measures are used: The French pica of 12 Didot points (also called cicero) generally is: 12 × 0.376 = 4.512 mm (0.1776 in).
The Fournier scale: two inches in total, divided into four half-inches, the medium intervals are one line (1 ⁄ 12 inch), and the smallest intervals are 1 ⁄ 36 inch; no intervals for the point is given, though. Fournier printed a reference scale of 144 points over two inches; however, it was too rough to accurately measure a single point. [11]
justified—text is aligned along the left margin, with letter-spacing and word-spacing adjusted so that the text falls flush with both margins, also known as fully justified or full justification; centered—text is aligned to neither the left nor right margin; there is an even gap on each side of each line.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
A board foot is a United States and Canadian unit of approximate volume, used for lumber. It is equivalent to 1 inch × 1 foot × 1 foot (144 cu in or 2,360 cm 3). It is also found in the unit of density pounds per board foot. In Australia and New Zealand the terms super foot or superficial foot were formerly used for this unit. The exact ...
There are more than 152 points in an inch, and 6 picas do not equal an inch. The metric equivalents are therefore off as well. You can look at any "pica pole," a form of ruler that most frequently displays both inches and picas with half-pica (6-point) increments also marked, the difference is quite noticeable at 12 inches, nearly 6 extra points.