Search results
Results from the WOW.Com Content Network
The Q-code is a standardised collection of three-letter codes that each start with the letter "Q". It is an operating signal initially developed for commercial radiotelegraph communication and later adopted by other radio services, especially amateur radio.
A signal strength and readability report is a standardized format for reporting the strength of the radio signal and the readability (quality) of the radiotelephone (voice) or radiotelegraph (Morse code) signal transmitted by another station as received at the reporting station's location and by their radio station equipment. These report ...
The book does not clarify the method for requesting an R-S-T report instead of a QSA report. [3] The U.S. Navy's Communications Instructions of 1929 prescribed a different set of codes for the response: [4] However, for joint Army-Navy operations, the K signal was replaced with the S signal, with exactly the same definitions. [5]
The Maidenhead Locator System (a.k.a. QTH Locator and IARU Locator) is a geocode system used by amateur radio operators to succinctly describe their geographic coordinates, which replaced the deprecated QRA locator, which was limited to European contacts. [1]
Radio communications, prior to the advent of landlines and satellites as communication paths and relays, was always subject to unpredictable fade outs caused by weather conditions, practical limits on available emission power at the transmitter, radio frequency of the transmission, type of emission, type of transmitting antenna, signal waveform characteristics, modulation scheme in use ...
A plain-language radio check is the means of requesting and giving a signal strength and readability report for radiotelephony (voice) communications, and is the direct equivalent to the QSA and QRK code used to give the same report in radiotelegraph communications.
Operating signals are a type of brevity code used in operational communication among radio and telegraph operators. For example: Prosigns for Morse code; 92 Code: telegraph brevity codes; Q code: initially developed for commercial radiotelegraph communication and adopted by other radio services; QN Signals: published by the ARRL and used in ...
The S stands for "Strength". Strength is an assessment of how powerful the received signal is at the receiving location. Although an accurate signal strength meter can determine a quantitative value for signal strength, in practice this portion of the RST code is a qualitative assessment, often made based on the S meter of the radio receiver at the location of signal reception.