enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Point (typography) - Wikipedia

    en.wikipedia.org/wiki/Point_(typography)

    A less precise definition is one pica equals 0.166 inches (4.2 mm), and one point 0.01383 inches (0.351 mm). [ 27 ] [ 33 ] It was also noticed that 83 picas is nearly equal to 35 cm, so the Type Founders Association also suggested using a 35 cm metal rod for measurements, but this was not accepted by every foundry.

  3. Table of handgun and rifle cartridges - Wikipedia

    en.wikipedia.org/wiki/Table_of_handgun_and_rifle...

    P: Momentum, in pound (force) (lbf) times seconds. [1] A guide to the recoil from the cartridge, and an indicator of bullet penetration potential. The .30-06 Springfield (at 2.064 lbf-s) is considered the upper limit for tolerable recoil for inexperienced rifle shooters. [2] Chg: Propellant charge, in grains; Dia: Bullet diameter, in inches

  4. .357 Magnum - Wikipedia

    en.wikipedia.org/wiki/.357_Magnum

    The .357 Smith & Wesson Magnum, .357 S&W Magnum, .357 Magnum, or 9×33mmR (as it is known in unofficial metric designation) is a smokeless powder cartridge with a 0.357 in (9.07 mm) bullet diameter.

  5. List of violent incidents involving Andrew Jackson - Wikipedia

    en.wikipedia.org/wiki/List_of_violent_incidents...

    Jackson was not seriously injured, if at all, and the pair later did business with one another. [ 28 ] [ 18 ] The indictment, written by future U.S. Senator Jenkin Whiteside , stated that the stab wound was .5 inches (13 millimeters) across and 4 inches (100 millimeters) deep. [ 29 ]

  6. Nominal Pipe Size - Wikipedia

    en.wikipedia.org/wiki/Nominal_Pipe_Size

    Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

  7. Metric typographic units - Wikipedia

    en.wikipedia.org/wiki/Metric_typographic_units

    In some special cases where finer resolution is required, it is permitted with sizes in multiples of 0.100 or 0.050 mm (respectively 2.5 and 5 times finer step sizes). [ 1 ] German graphic designer and typographer Otl Aicher (1922 – 1991) vividly encouraged the use of the quart, and provided a suggested list of common sizes:

  8. Digital card - Wikipedia

    en.wikipedia.org/wiki/Digital_card

    The magnetic stripe is located 0.223 inches (5.7 mm) from the edge of the card, and is 0.375 inches (9.5 mm) wide. The magnetic stripe contains three tracks, each 0.110 inches (2.8 mm) wide. Tracks one and three are typically recorded at 210 bits per inch (8.27 bits per mm), while track two typically has a recording density of 75 bits per inch ...

  9. Chevrolet big-block engine - Wikipedia

    en.wikipedia.org/wiki/Chevrolet_big-block_engine

    The Chevrolet big-block engine is a series of large-displacement, naturally-aspirated, 90°, overhead valve, gasoline-powered, V8 engines that was developed and have been produced by the Chevrolet Division of General Motors from the late 1950s until present.