enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Spotface - Wikipedia

   en.wikipedia.org/wiki/Spotface

   The most common application of spotfacing (spot facing) is facing the area around a bolt hole where the bolt's head will sit, which is often done by cutting a shallow counterbore, just deep enough "to clean up"—that is, only enough material is removed to get down past any irregularity and thus make the surface flat. [1]

3. Facing (machining) - Wikipedia

   en.wikipedia.org/wiki/Facing_(machining)

   This process removes the material by rotating the facing tool in the counterclockwise direction as the table feeds the work piece across the cutter. Face milling can be achieved with an end mill, but is often done with a face mill, shell mill or a fly cutter. Face milling can be done in both manual machining and CNC machining. To obtain a ...

4. Counterbore - Wikipedia

   en.wikipedia.org/wiki/Counterbore

   The pilot matters little when running the cutter in a milling setup where rigidity is assured and hole center location is already achieved via X-Y positioning. The uppermost counterbore tools shown in the image are the same device. The smaller top item is an insert, the middle shows another three-fluted counterbore insert, assembled in the holder.

5. Surface grinding - Wikipedia

   en.wikipedia.org/wiki/Surface_grinding

   Surface grinding is a finishing process that uses a rotating abrasive wheel to smooth the flat surface of metallic or nonmetallic materials to give them a more refined look by removing the oxide layer and impurities on work piece surfaces. This will also attain a desired surface for a functional purpose.

6. Multiaxis machining - Wikipedia

   en.wikipedia.org/wiki/Multiaxis_machining

   A 5-axis water jet cutter and a part manufactured with it. Multiaxis machining is a manufacturing process that involves tools that move in 4 or more directions and are used to manufacture parts out of metal or other materials by milling away excess material, by water jet cutting or by laser cutting. This type of machining was originally ...

7. CNC wood router - Wikipedia

   en.wikipedia.org/wiki/CNC_wood_router

   Cutting bit rotation speeds on metal working equipment is typically too slow to produce good results in wood. Typical wood piece before router cutting Typical work done by a CNC wood router. A CNC wood router is a CNC router tool that creates objects from wood. CNC stands for computer numerical control. The CNC works on the Cartesian coordinate ...

8. Kent State with loss to Buffalo could complete the worst ...

   www.aol.com/kent-state-loss-buffalo-could...

   Editor's note: Kent State lost to Buffalo 43-7 on Tuesday night to finish the season 0-12. Running back Jaylen Thomas’ 23-yard touchdown run with 2:28 left in the third quarter put the finishing ...

9. Turning - Wikipedia

   en.wikipedia.org/wiki/Turning

   Turning is a machining process in which a cutting tool, typically a non-rotary tool bit, describes a helix toolpath by moving more or less linearly while the workpiece rotates. Usually the term "turning" is reserved for the generation of external surfaces by this cutting action, whereas this same essential cutting action when applied to ...