Search results
Results from the WOW.Com Content Network
Dialing *70 can prevent the call from completing when the phone line does not have the call waiting feature active. Leave this option unchecked if you are no longer able to connect. 3. Check or uncheck, “I have to dial this number to reach an outside line” depending on your telephone line. Normally, this should not be selected.
However, although rarely connected in practice, Irish phone jacks also contain a ringing capacitor circuit very similar to their UK counterparts. This is carried on pin 5. Or, if wired for two-line service (rare), a second ring wire is carried on pin 2 for line 2, with the outer pair, pins 1 and 6 carrying the second line.
Check the physical connection - A loose cable or cord can often be the cause of a connection problem. Make sure everything is securely connected to the wall and device. 3. Reboot your modem/router - Sometimes the old "turn it off and on again" approach actually does work! Just wait about five minutes before turning it back on to make sure ...
If a phone receiver is left off-hook, some phone systems may use an intercept message to inform callers to hang up their phone receivers. The most common message reads as follows: If you'd like to make a call, please hang up and try again. If you need help, hang up and then dial your operator. A formerly-used variation of this message was as ...
telephone line to phone cord: The wall jack. This connection is the most standardized, and often regulated as the boundary between an individual's telephone and the telephone network. In many residences, though, the boundary between utility-owned and household-owned cabling is a network interface on an outside wall known as the demarcation ...
The first subscriber's phone (called the 'audio customer') would be connected as normal. The second subscriber (called the 'carrier customer') would have his phone calls modulated on to an RF carrier or Carrier wave on the same physical phone line at around 40 kHz – high enough not to be noticeable to the audio customer.
Bluetooth devices intended for use in short-range personal area networks operate from 2.4 to 2.4835 GHz. To reduce interference with other protocols that use the 2.45 GHz band, the Bluetooth protocol divides the band into 80 channels (numbered from 0 to 79, each 1 MHz wide) and changes channels up to 1600 times per second.
Cords connecting to an RJ11 interface require a 6P2C connector. Nevertheless, cords sold as RJ11 often use 6P4C connectors (six position, four conductor) with four wires. Two of the six possible contact positions connect tip and ring, and the other two conductors are unused. RJ11 is commonly used to connect DSL modems to the customer line.