enow.com Web Search

  1. Ads

    related to: nut bolt drawing with dimensions

Search results

  1. Results from the WOW.Com Content Network
  2. British Association screw threads - Wikipedia

    en.wikipedia.org/wiki/British_Association_screw...

    The major diameter is given by 6p 1.2, [4]: 12 rounded to two significant figures in mm and the hex head size (across the flats) is 1.75 times the major diameter. BA sizes are specified by the following British Standards: BS 57:1951 — B.A. screws, bolts and nuts

  3. Unified Thread Standard - Wikipedia

    en.wikipedia.org/wiki/Unified_Thread_Standard

    Even though #14 and #16 screws are still available, they are not as common as sizes #0 through #12. [citation needed] Sometimes "special" diameter and pitch combinations (UNS) are used, for example a 0.619 in (15.7 mm) major diameter with 20 threads per inch. UNS threads are rarely used for bolts, but rather on nuts, tapped holes, and threaded ODs.

  4. ISO metric screw thread - Wikipedia

    en.wikipedia.org/wiki/ISO_metric_screw_thread

    Other (usually smaller) sizes may occur to reduce weight or cost, including the small series flange bolts defined in ISO 4162 which typically have hexagonal head sizes corresponding to the smaller 1st choice thread size (eg. M6 small series flange bolts have 8mm hexagonal heads, as would normally be found on M5 bolts). [10]

  5. Screw thread - Wikipedia

    en.wikipedia.org/wiki/Screw_thread

    The minimum limits for external (or bolt, in ISO terminology), and the maximum limits for internal (nut), thread sizes are there to ensure that threads do not strip at the tensile strength limits for the parent material. The minimum limits for internal, and maximum limits for external, threads are there to ensure that the threads fit together.

  6. ASTM A325 - Wikipedia

    en.wikipedia.org/wiki/ASTM_A325

    Dimensions of heavy hex geometry are per document ANSI/ASME B18.2.6, which uses "coarse" threads as defined by Unified Thread Standard. ASTM 325 bolts can be considered equivalent to Grade 8.8 bolts according to ASTM F568M. [citation needed] For a higher strength version of this type of bolt, see ASTM A490.

  7. List of DIN standards - Wikipedia

    en.wikipedia.org/wiki/List_of_DIN_standards

    Technical drawings – Axonometric projections, Isometric projection ... Selected sizes for screws, bolts and nuts from 1 to 52 mm screw thread diameter and limits of ...

  1. Ads

    related to: nut bolt drawing with dimensions