Ads
related to: sterling 10.5 axle locker parts list
Search results
Results from the WOW.Com Content Network
The Sterling 10.5 axle is an automotive axle manufactured by Ford Motor Company at the Sterling Axle Plant in Sterling Heights, MI. It was first used in model year 1985 Ford trucks. The axle was developed to replace the Dana 60 and Dana 70. The Sterling 10.5 axle is currently only made as a full floating axle.
Pages in category "Automobile axles" The following 16 pages are in this category, out of 16 total. ... Saginaw 9.5-inch axle; Sterling 10.5 axle This page was ...
There are discernible differences between the GM and Ram versions, evident in the gaskets used and the axle cover designs. The GM AAM axle tubes exhibit a smaller diameter at the spindle compared to the AAM Dodge axles—measuring 4" for GM and 3.5" for Dodge from the housing. In design variation, newer GM trucks are aligned with Dodge axles.
The F-250 and F-350 single-rear-wheel versions were fitted with a 10.5-inch (270 mm) Sterling 10.5 35-spline axle with choices of conventional or limited-slip differentials; initially developed for previous-generation Ford trucks, it was strengthened for use in the Super Duty. In dual-rear-wheel F-350s, the rear axle was a Dana 80.
The Dana 70 axle only came with 5.13:1, 4.88,5.31 [citation needed] gear ratios and had a GAWR of [citation needed] these axles were rated at 7-9klbs as seen on 5500 door stickers. They differ greatly from previous Dana 70 front axles, some of the major differences being the use of 1550 Universal Joints and being a high pinion, reverse cut axle.
The four-wheel-drive models had an NV273 transfer case and Dana 50 front axle. Rear axle ratios of 3.73:1 and 4.30:1 were offered. Rear axle ratios of 3.73:1 and 4.30:1 were offered. During the development of the chassis, Ford learned that its initial design caused smaller vehicles (such as a Ford Taurus ) to become severely overridden in a ...
Dana differential case #706400 [3] (3.07-3.73) shows in Dana's parts catalog to be Dana 61-specific [citation needed]. The 706040x carrier can be purchased relatively inexpensively and used to install lower gears in a Dana 61 axle, such as when replacing a broken or damaged Dana 60 with a Dana 61 while retaining the factory gear ratio.
The same year, Ford introduced the H-Series heavy truck. Derived from the C-Series, the H-Series mounted the cab higher on an all-new chassis with a forward-mounted axle (taking on the "Two-Story Falcon" nickname); while a Super Duty V8 was standard, the optional Cummins NH inline-6 was the first factory-installed diesel offered in a Ford truck ...
Ads
related to: sterling 10.5 axle locker parts list