enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Sheet metal - Wikipedia

   en.wikipedia.org/wiki/Sheet_metal

   In the U.S., the thickness of sheet metal is commonly specified by a traditional, non-linear measure known as its gauge. The larger the gauge number, the thinner the metal. Commonly used steel sheet metal ranges from 30 gauge to about 7 gauge. Gauge differs between ferrous metals and nonferrous metals such as aluminum or copper. Copper ...

3. Corrugated galvanised iron - Wikipedia

   en.wikipedia.org/wiki/Corrugated_galvanised_iron

   Corrugated galvanised iron (CGI) or steel, colloquially corrugated iron (near universal), wriggly tin (taken from UK military slang), pailing (in Caribbean English), corrugated sheet metal (in North America), zinc (in Cyprus and Nigeria) or custom orb / corro sheet (Australia), is a building material composed of sheets of hot-dip galvanised ...

4. Truss connector plate - Wikipedia

   en.wikipedia.org/wiki/Truss_connector_plate

   A truss connector plate is manufactured from ASTM A653/A653M, A591, A792/A792M, or A167 structural quality steel and is protected with zinc or zinc-aluminum alloy coatings or their stainless steel equivalent. Metal connector plates are manufactured with varying length, width and thickness (or gauge) and are designed to laterally transmit loads ...

5. Steel grades - Wikipedia

   en.wikipedia.org/wiki/Steel_grades

   Steel specified by purpose of use and mechanical properties. ... So S355 has a minimum yield strength of 355 MPa for the smallest thickness range covered by the ...

6. Hot-dip galvanization - Wikipedia

   en.wikipedia.org/wiki/Hot-dip_galvanization

   The British, European and International standard for hot-dip galvanizing is BS EN ISO 1461, which specifies a minimum coating thickness to be applied to steel in relation to the steels section thickness e.g. a steel fabrication with a section size thicker than 6 mm shall have a minimum galvanized coating thickness of 85 μm.

7. Cold-formed steel - Wikipedia

   en.wikipedia.org/wiki/Cold-formed_steel

   When thickness less than or equal to 3/16" (4.76mm): The various possible welds in cold formed steel sections, where the thickness of the thinnest element in the connection is 3/16" or less are as follows Groove Welds in Butt joints; Arc Spot Welds; Arc Seam Welds; Fillet Welds; Flare Groove Welds; 2.When thickness greater than or equal to 3/16 ...