Ads
related to: top break action revolverebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
The Smith & Wesson Model 3 is a single-action, cartridge-firing, top-break revolver produced by Smith & Wesson (S&W) from around 1870 to 1915, and was recently again offered as a reproduction by Smith & Wesson and Uberti.
As early as 1853 P. Webley and J. Webley began production of their first patented single action cap and ball revolvers. Later under the trade name of P. Webley and Son, manufacturing included their own 0.44 in (11 mm) calibre rim-fire solid frame revolver as well as licensed copies of Smith & Wesson's Tip up break action revolvers. The ...
Close-up of an IOF 32 break-action revolver. The first break-action revolver was patented in France and Britain at the end of December in 1858 by Devisme. [1] A substantial hinge pin joins the two parts of the rifle or shotgun; the stock with its firing mechanism and the fore-piece and barrel, which hold the round to be fired.
The final version of these top-break double-action 38's was the Perfected Model. This version used a top break with a sideplate thumb latch and was made from 1909 until 1920 for a total of 59,400 revolvers. This model was used by Floyd Allen in a courthouse escape attempt in 1913. [1]
The Enfield No. 2 was a British top-break revolver using the .38 S&W round manufactured from 1930 to 1957. It was the standard British/Commonwealth sidearm in the Second World War, alongside the Webley Mk IV and Smith & Wesson Victory Model revolvers chambered in the same calibre.
The American Double Action (large solid frame centerfire revolver) Manufactured 1883–1941. Calibers: .32, .38 and .44 (850,000 were manufactured). H&R Bulldog (large solid frame rimfire revolver) Caliber: .32 rimfire; Top-break Shell Extracting Revolver (Manual Ejecting Model).32 S&W, .32 H&R, or .38 S&W; 5- or 6- shot. Build on the same ...
An IOF .32 top-break revolver. In a top-break revolver, the frame is hinged at the bottom front of the cylinder. Releasing the lock and pushing the barrel down exposes the rear face of the cylinder. In most top-break revolvers, this act also operates an extractor that pushes the cartridges in the chambers back far enough that they will fall ...
The Model 1 + 1 ⁄ 2 had three issues. The first two (known as the first and second issues) were "tip-up" revolvers with the barrel release catch located on the side of the frame in front of the trigger, while the third (known as the "Model 1 + 1 ⁄ 2 Single Action Revolver") was a "top-break", with the barrel release catch located on the top of the frame, just in front of the hammer.
Ads
related to: top break action revolverebay.com has been visited by 1M+ users in the past month