Search results
Results from the WOW.Com Content Network
For example, a VLAN can be used to separate traffic within a business based on individual users or groups of users or their roles (e.g. network administrators), or based on traffic characteristics (e.g. low-priority traffic prevented from impinging on the rest of the network's functioning).
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
This allows an attacker's fake VLAN tag to be read by the next switch. [4] Double tagging can be mitigated by any of the following actions (incl. IOS example): Simply do not put any hosts on VLAN 1 (the default VLAN). i.e., assign an access VLAN other than VLAN 1 to every access port Switch (config-if)# switchport access vlan 2
Example without and with VTP. On Cisco Devices, VTP (VLAN Trunking Protocol) maintains VLAN configuration consistency across a single Layer 2 network. VTP uses Layer 2 frames to manage the addition, deletion, and renaming of VLANs from switches in the VTP client mode. VTP is responsible for synchronizing VLAN information within a VTP domain and ...
A Private VLAN divides a VLAN (Primary) into sub-VLANs (Secondary) while keeping existing IP subnet and layer 3 configuration. A regular VLAN is a single broadcast domain, while private VLAN partitions one broadcast domain into multiple smaller broadcast subdomains. Primary VLAN: Simply the original VLAN. This type of VLAN is used to forward ...
An example of how to configure a simple, three switch MSTP topology wherein a layer-two access switch carries four VLANs and has two uplinks to two distribution switches, can be found here: MSTP Configuration Guide A good configuration view, from the above-mentioned example shall be: S3# show spanning-tree mst
The idea is to provide, for example, the possibility for customers to run their own VLANs inside a service provider's provided VLAN. This way the service provider can just configure one VLAN for the customer and the customer can then treat that VLAN as if it were a trunk. IEEE 802.1ad was created for the following reasons:
This is known as inter-VLAN routing. On layer-3 switches it is accomplished by the creation of layer-3 interfaces (SVIs). Inter VLAN routing, in other words routing between VLANs, can be achieved using SVIs. [1] SVI or VLAN interface, is a virtual routed interface that connects a VLAN on the device to the Layer 3 router engine on the same device.