Search results
Results from the WOW.Com Content Network
Serial communication is used for all long-haul communication and most computer networks, where the cost of cable and synchronization difficulties make parallel communication impractical. Serial computer buses have become more common even at shorter distances, as improved signal integrity and transmission speeds in newer serial technologies have ...
Parallel versus serial communication. In data transmission, parallel communication is a method of conveying multiple binary digits simultaneously using multiple conductors. This contrasts with serial communication, which conveys only a single bit at a time; this distinction is one way of characterizing a communications link.
At the destination, a second UART re-assembles the bits into complete bytes. Each UART contains a shift register, which is the fundamental method of conversion between serial and parallel forms. Serial transmission of digital information (bits) through a single wire or other medium is less costly than parallel transmission through multiple wires.
Practically all parallel communications protocols use synchronous transmission. For example, in a computer, address information is transmitted synchronously—the address bits over the address bus, and the read or write strobes of the control bus. Single-wire synchronous signalling
Data communication, including data transmission and data reception, is the transfer of data, transmitted and received over a point-to-point or point-to-multipoint communication channel. Examples of such channels are copper wires , optical fibers , wireless communication using radio spectrum , storage media and computer buses .
Parallel communication; Parity bit; Payload (computing) Percept (information technology) Petherick code; Phase-fired controller; Phase-shift keying; Piggybacking (data transmission) Polar modulation; Primary station; Protocol data unit; Public data transmission service; Public switched data network
USARTs in synchronous mode transmits data in frames. In synchronous operation, characters must be provided on time until a frame is complete; if the controlling processor does not do so, this is an "underrun error," and transmission of the frame is aborted. USARTs operating as synchronous devices used either character-oriented or bit-oriented mode.
In telecommunications, transmission (sometimes abbreviated as "TX") is the process of sending or propagating an analog or digital signal via a medium that is wired, wireless, or fiber-optic. [ 1 ] [ 2 ]