Search results
Results from the WOW.Com Content Network
The Turner-Sclerometer test consists of measuring the amount of load required to make a scratch. [1] [2] In test a weighted diamond point is drawn, once forward and once backward, over the smooth surface of the material to be tested. The hardness number is the weight in grams required to produce a standard scratch.
The test hammer hits the concrete at a defined energy. Its rebound is dependent on the hardness of the concrete and is measured by the test equipment. By reference to a conversion chart, the rebound value can be used to determine the concrete's compressive strength. When conducting the test, the hammer should be held at right angles to the ...
The flow table test or slump-flow test is a method to determine consistency of fresh concrete. Flow table test is also used to identify transportable moisture limit of solid bulk cargoes. [ 1 ] It is used primarily for assessing concrete that is too fluid (workable) to be measured using the slump test , because the concrete will not retain its ...
The principle is that an object made of a harder material will scratch an object made of a softer material. When testing coatings, scratch hardness refers to the force necessary to cut through the film to the substrate. The most common test is Mohs scale, which is used in mineralogy. One tool to make this measurement is the sclerometer.
The test is carried out using a metal mould in the shape of a conical frustum known as a slump cone or Abrams cone, that is open at both ends and has attached handles.The tool typically has an internal diameter of 100 millimetres (3.9 in) at the top and of 200 millimetres (7.9 in) at the bottom with a height of 305 millimetres (12.0 in).The cone is placed on a hard non-absorbent surface.
Shopping, preparing and cleaning up after a meal involves a lot of labor (and a fair amount of time). Plus, the potential for mealtime indecision is higher than ever, thanks to the countless ...
ISO 3766:2003 Construction drawings – Simplified representation of concrete reinforcement; ISO 3767 Tractors, machinery for agriculture and forestry, powered lawn and garden equipment – Symbols for operator controls and other displays ISO 3767-1:2016 Part 1: Common symbols; ISO 3767-2:2016 Part 2: Symbols for agricultural tractors and machinery
The scraper is a large piece of equipment which is used in mining, construction, agriculture and other earthmoving applications. The rear part has a vertically moveable hopper (also known as the bowl) with a sharp horizontal front edge. The hopper can be hydraulically lowered and raised.