Ads
related to: new throttle body not working on fordebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
The result is an engine that fails to maintain idle RPM and frequently stalls. A jammed actuator may be freed simply by cleaning it. However an actuator that has stopped working due to a fault in its servomotor will need replacement. Air leaks in either the stepper housing or pipes will cause elevated idle RPM.
A throttle position sensor (TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used.
Accelerate-by-wire or throttle-by-wire, [17] more commonly known as electronic throttle control, is a system that actuates vehicle propulsion without any mechanical connections, such as cables, from the accelerator pedal to the throttle valve of the engine or other propulsion systems. In electric vehicles, this system controls the electric ...
In fuel injected engines, the throttle body is the part of the air intake system that controls the amount of air flowing into the engine, in response to driver accelerator pedal input in the main. The throttle body is usually located between the air filter box and the intake manifold, and it is usually attached to, or near, the mass airflow sensor.
A typical naturally aspirated engine configuration employs one or the other, whereas forced induction engines typically use both; a MAF sensor on the Cold Air Intake leading to the turbo and a MAP sensor on the intake tract post-turbo before the throttle body on the intake manifold.
EEC-III on carbureted cars controlled the same Ford 7200 VV carburetor as the EEC-II. On fuel-injected cars, the module fired two high pressure (approximately 40 psi) fuel injectors that were mounted in a throttle body attached to a traditional intake manifold in the center valley of the 5.0 liter (302 cid) engine.
The closed throttle provides engine braking by forcing the engine to generate a vacuum between the throttle and the cylinders. Typically, the controls for a compression brake consist of an on/off switch and often a selector that controls the number of cylinders on which the brake is active. Throttle and clutch switches are integral with the system.
Ads
related to: new throttle body not working on fordebay.com has been visited by 1M+ users in the past month