enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Gimlet (tool) - Wikipedia

   en.wikipedia.org/wiki/Gimlet_(tool)

   A gimlet is a hand tool for drilling small holes, mainly in wood, without splitting. It was defined in Joseph Gwilt's Architecture (1859) as "a piece of steel of a semi-cylindrical form, hollow on one side, having a cross handle at one end and a worm or screw at the other". [1] A gimlet is always a small tool.

3. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   While the above is a common use of center drill bits, it is a technically incorrect practice and should not be considered for production use. The correct tool to start a traditionally drilled hole (a hole drilled by a high-speed steel (HSS) twist drill bit) is a spotting drill bit (or a spot drill bit, as they are referenced in the U.S.). The ...

4. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Example (inch, fine): For 7 ⁄ 16-20 (same diameter as the previous example, but this time with 20 threads per inch, which is considered fine), 0.437 in × 0.90 = 0.393 in (i.e., if the threads are to be fine, then a slightly larger diameter drill bit should be used before tapping the hole for the screw).

5. Brace (tool) - Wikipedia

   en.wikipedia.org/wiki/Brace_(tool)

   Turning the spindle of the chuck in a clockwise direction tightens the drill bit in the chuck; turning counterclockwise loosens the bit for removal. A carpenter using a brace. In most modern braces, immediately behind the chuck is a three position gear release that allows ratcheting of the handle when in tight spots. Turning the gear release ...

6. Watts Brothers Tool Works - Wikipedia

   en.wikipedia.org/wiki/Watts_Brothers_Tool_Works

   Watts Brothers Tool Works is a tool manufacturer located in Wilmerding, Pennsylvania.They are known for manufacturing drill bits that can drill square holes, [1] [2] including blind holes, which cannot be made with other methods such as broaching.

7. Drill cuttings - Wikipedia

   en.wikipedia.org/wiki/Drill_cuttings

   Drill cuttings [1] are broken bits of solid material removed from a borehole drilled by rotary, percussion, or auger methods and brought to the surface in the drilling mud. Boreholes drilled in this way include oil or gas wells, water wells, and holes drilled for geotechnical investigations or mineral exploration. [2]