enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of polyurethane applications - Wikipedia

   en.wikipedia.org/wiki/List_of_polyurethane...

   Industrial Insulation. Rigid polyurethane foam is used in various industries to provide thermal insulation to installations and pipes. In particular, the piping for district heating systems in Europe is primarily insulated using a pre-insulated pipes sandwich assembly composed of a steel heat service pipe, an insulating layer (polyurethane foam) and a polyethylene (PE) casing, which are bonded ...

3. Microducts - Wikipedia

   en.wikipedia.org/wiki/Microducts

   As indicated in GR-3155, cable is typically placed into the duct in one of three ways: It may be pre-installed by the duct manufacturer during the extrusion process. It may be pulled into the duct using a mechanically assisted or hand-drawn pull line. It may be blown into the duct using a high air volume cable blowing apparatus.

4. Process duct work - Wikipedia

   en.wikipedia.org/wiki/Process_Duct_Work

   Duct plate 3/16", or thinner, may dishpan, or make noise, and should be avoided. Rectangular duct section properties are calculated from the distance between the upper to lower duct corners of the ductwork The flanges areas are based on the size of corner angles plus duct plate width based on the plate thickness ratio of 16*t.

5. IEC 60228 - Wikipedia

   en.wikipedia.org/wiki/IEC_60228

   Comparison of SWG (red), AWG (blue) and IEC 60228 (black) wire gauge sizes from 0.03 to 200 mm² to scale on a 1 mm grid – in the SVG file, hover over a size to highlight it. In engineering applications, it is often most convenient to describe a wire in terms of its cross-section area, rather than its diameter, because the cross section is directly proportional to its strength and weight ...

6. Duct (flow) - Wikipedia

   en.wikipedia.org/wiki/Duct_(flow)

   Some flexible duct markets prefer to avoid using flexible duct on the return air portions of HVAC systems, however flexible duct can tolerate moderate negative pressures. The UL181 test requires a negative pressure of 200 Pa. To use flexible ducting in a system, make sure to pull the duct tight so you get the full internal diameter.

7. Cross-linked polyethylene - Wikipedia

   en.wikipedia.org/wiki/Cross-linked_polyethylene

   A cross-linked polyethylene (PEX) pipe. Cross-linked polyethylene, commonly abbreviated PEX, XPE or XLPE, is a form of polyethylene with cross-links.It is used predominantly in building services pipework systems, hydronic radiant heating and cooling systems, domestic water piping, insulation for high tension (high voltage) electrical cables, and baby play mats.