Search results
Results from the WOW.Com Content Network
Pages in category ".454 Casull firearms" The following 7 pages are in this category, out of 7 total. This list may not ... Ruger Blackhawk; Ruger Super Redhawk; S ...
The .480 Ruger is built on the same frame as the .454 Casull, and was introduced as a six-shot model. While the .480 Ruger is not loaded to the rifle-like pressures of the .454 Casull, the bigger (.475 caliber, 12 mm) bore allows the use of heavier bullets than the .454 Casull, making it a good choice for handgun hunting.
The .454 Casull generates almost five times the recoil of the .45 Colt, and about 75% more recoil energy than the .44 Magnum. [6] It can deliver a 250 grain (16 g) bullet with a muzzle velocity of over 1,900 feet per second (580 m/s), developing up to 2,000 ft-lb (2.7 kJ ) of energy from a handgun.
Pages in category "Ruger semi-automatic pistols" The following 10 pages are in this category, out of 10 total. This list may not reflect recent changes. P.
The Ruger P91 is essentially a Ruger P89 chambered in .40 Smith & Wesson. Like its precursors, it also had an investment cast aluminum alloy frame. It was only produced for two years, from 1992 to 1994. It has a magazine capacity of 11 rounds, with 10 round magazines being developed for the 1994 ban. KP94DC, decock-only model
Earlier models were listed as .44 caliber, later as .45, but all use a .457" round ball or .454" conical lead bullet. [3] The Ruger Old Army can also shoot modern smokeless cartridges in .45 Colt (.45 Long Colt), or .45 ACP loaded for "cowboy action" muzzle velocities less than about 850 feet per second, via use of a drop-in conversion cylinder ...
Ruger Wrangler; S. Ruger SP101 This page was last edited on 21 November 2023, at 21:48 (UTC). Text is available under the Creative Commons Attribution-ShareAlike 4.0 ...
The Ruger Wrangler is a single-action rimfire revolver produced by Sturm, Ruger & Co. Chambered for .22 Long Rifle cartridges, it was announced in April 2019. [2] The revolver makes extensive use of aluminum and zinc castings for ease of manufacturability, [3] and also has an unfluted cylinder and uses metal injection molded components for further cost reduction. [4]