Search results
Results from the WOW.Com Content Network
VEIS: Vent, enter, isolate, search - a further development of the VES concept, emphasizing the importance of isolating the room being searched from the rest of the building containing the seat of fire, by closing the door as soon as such door is found, in order to improve the tenability and visibility in the room.
The internal air is forced out so that negative air pressure is created pulling air passively into the system from other inlets. Negative room pressure is an isolation technique used in hospitals and medical centers to prevent cross-contamination from room to room.
Blow-by, as it is often called, is the result of combustion material from the combustion chamber "blowing" past the piston rings and into the crankcase. These blow-by gases, if not ventilated, inevitably condense and combine with the oil vapor present in the crankcase, forming oil sludge.
In the U.S., every plumbing fixture must also be coupled to the system's vent piping. [1] Without a vent, negative pressure can slow the flow of water leaving the system, resulting in clogs, or cause siphonage to empty a trap. The high point of the vent system (the top of its "soil stack") must be open to the exterior at atmospheric pressure.
Gasper vent over passenger seats of a Boeing 737-800 Gaspers [ a ] usually receive their air from the AC PACKs aboard the aircraft, which in turn receive compressed, clean air from the compressor stages of the aircraft's jet engines or when on the ground from the auxiliary power unit (APU) or a ground source.
A Block and bleed manifold is a hydraulic manifold that combines one or more block/isolate valves, usually ball valves, and one or more bleed/vent valves, usually ball or needle valves, into one component for interface with other components (pressure measurement transmitters, gauges, switches, etc.) of a hydraulic system. The purpose of the ...
An isolation valve is a valve in a fluid handling system that stops the flow of process media to a given location, usually for maintenance or safety purposes. [1] They can also be used to provide flow logic (selecting one flow path versus another), and to connect external equipment to a system. [2]
The majority of guidance available for design of heat and smoke building vents installed in buildings is restricted to nonsprinklered, single-story buildings. [4] This is partly a historical consequence of the installation of heat and smoke vents following the August 1953 General Motors, Livonia, MI major fire in a nonsprinklered manufacturing facility which effectively stopped the production ...