enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Grounding resistance tester - Wikipedia

   en.wikipedia.org/wiki/Grounding_resistance_tester

   A grounding resistance tester also called an earth tester is a ... to reliably and efficiently ground the installation. [6] ... tester Fluke 1621 digital ...

3. Fluke Corporation - Wikipedia

   en.wikipedia.org/wiki/Fluke_Corporation

   Fluke purchased the testing and measurements division of Philips in 1993 for $41.8 million. [2] The Philips PM series of measurement instruments was rebranded as Fluke. Fluke was bought by the Danaher Corporation in 1998. Danaher spun off several subsidiaries, including Fluke, in 2016 to create Fortive. [3]

4. Megohmmeter - Wikipedia

   en.wikipedia.org/wiki/Megohmmeter

   Megohmmeter M1101M. A Megohmmeter or insulation resistance tester, is a special type of ohmmeter used to measure the electrical resistance of insulators. [1] Insulating components, for example cable jackets, must be tested for their insulation strength at the time of commissioning and as part of maintenance of high voltage electrical equipment and installations.

5. Dielectric withstand test - Wikipedia

   en.wikipedia.org/wiki/Dielectric_withstand_test

   An insulation test set; in this pattern, a hand-cranked generator provides the high voltage and the scale is directly calibrated in megohms. Voltage withstand testing is done with a high-voltage source and voltage and current meters. A single instrument called a "pressure test set" or "hipot tester" is often used to perform this test.

6. Copper cable certification - Wikipedia

   en.wikipedia.org/wiki/Copper_cable_certification

   The delay skew test is used to find the difference in propagation delay between the fastest and slowest set of wire pairs. An ideal skew is between 25 and 50 nanoseconds over a 100-meter cable. The lower this skew the better; less than 25 ns is excellent, but 45 to 50 ns is marginal.

7. Multimeter - Wikipedia

   en.wikipedia.org/wiki/Multimeter

   Testing often requires that the component under test be isolated from the circuit in which they are mounted, as otherwise stray or leakage current paths may distort measurements. In some cases, the voltage from the multimeter may turn active devices on, distorting a measurement, or in extreme cases even damage an element in the circuit being ...