Search results
Results from the WOW.Com Content Network
A roller brake tester is a method of allowing the dynamic assessment of the braking system of a motor vehicle, whilst the vehicle itself is in a static condition.This type of brake tester is normally used in UK garages when used as part of an inspection lane for the MOT test.
Prony brake dynamometers at a tractor contest in 1910 Schematic of a Prony brake Actual Prony Brake built for testing 5HP Steam Engine. The Prony brake is a simple device invented by Gaspard de Prony in 1821 to measure the torque produced by an engine. The term "brake horsepower" is one measurement of power derived from this method of measuring ...
The length of the braking test track at the Aldenhoven Testing Center is 150 m, which contains an asphalt and a ceramic pavement lane. Both lanes are 4 m wide and may be wetted as preferred. The braking test lane is surrounded on both sides by a safety zone. A 200 m access acceleration lane is also part of the braking test track. [3]
A 'motoring' dynamometer provides the features of a brake dyno system, but in addition, can "power" (usually with an AC or DC motor) the PM and allow testing of very small power outputs (for example, duplicating speeds and loads that are experienced when operating a vehicle traveling downhill or during on/off throttle operations).
The purpose is to reduce failures in hydraulic braking systems of motor vehicles which may occur because of the manufacture or use of improper or contaminated fluid. The standard applies to all fluid use of passenger cars, multipurpose passenger vehicles, trucks, buses, trailers and motorcycles equipped with a hydraulic brake system. [1]
A chassis dynamometer, informally referred to as a rolling road [1] or a dyno, is a mechanical device that uses one or more fixed roller assemblies to simulate different road conditions within a controlled environment, and is used for a wide variety of vehicle testing and development purposes. All Wheel Drive Chassis Dynamometer
Rear-end collision is a possible outcome from brake checking.. A brake check, also known as a brake test, occurs when a driver deliberately either taps on the brakes several times or slams hard on the pedal when moving in front of another vehicle, with the intention of causing the behind driver to either collide or take evasive action. [1]
AEB differs from forward collision warning: FCW alerts the driver with a warning but does not by itself brake the vehicle. [4] According to Euro NCAP, AEB has three characteristics: [5] Autonomous: the system acts independently of the driver to avoid or mitigate the accident. Emergency: the system will intervene only in a critical situation.