Search results
Results from the WOW.Com Content Network
Firebox of a GWR 6959 Class steam locomotive, showing the underside of the brick arch, constructed from specially-shaped firebricks. Empty firebox of a Baureihe 52, showing the brick arch. There is a large brick arch (made from fire brick) attached to the front wall (boiler throat plate) of the firebox immediately beneath the firetubes. This ...
The hatched circles show the outline of the barrel to which the firebox was attached. A Round-topped firebox cross section shown for comparison. Note the angling of the stays. Pacific-type flat-topped inner firebox. The Belpaire firebox is a type of firebox used on steam locomotives. It was invented by Alfred Belpaire of Belgium in 1864. Today ...
This page was last edited on 3 February 2011, at 11:44 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.
The typical locomotive firebox of the day was long and narrow, fitting in between the locomotive's frames. The successful design of a trailing truck with the firebox mounted behind the driving wheels (e.g. the Pacific or 4-6-2 class) not yet been developed. Wootten instead mounted his huge firebox above the locomotive's driving wheels. The ...
The square-topped Belpaire firebox allows steam to be conveniently collected at its top corners and therefore locomotives with Belpaire fireboxes often dispensed with a dome, for example express engines such as the GWR Castle Class (the large brass boiler fitting on a Castle is the distinctive GWR safety valve cover, not a dome).
(UP drawings reproduced in Kratville and Bush's Union Pacific Type books show the inside rod 113 in (290 cm) long and the first and second driver axles 88 in (220 cm) apart. The inside cylinder axis was inclined 9.5 degrees and was 32 in (81 cm) above the plane of the driving axles at a point 181 in (460 cm) ahead of the second driving axle, so ...
The 'waisted' firebox is at the far end of the boiler. A round-topped boiler is a type of boiler used for some designs of steam locomotive and portable engine. It was an early form of locomotive boiler, although continuing to be used for new locomotives through to the end of steam locomotive manufacture in the 1960s.
Compartment where the engineer (US+) / driver (UK+) and fireman control the locomotive and tend the steam supply and firebox. [2] [3]: 15 They achieve that using various devices, most of which are on the rear surface of the firebox, called the "backhead": [4] Most controls are mounted on the boiler's backhead