enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Radio receiver design - Wikipedia

    en.wikipedia.org/wiki/Radio_receiver_design

    A crystal set receiver consisting of an antenna, a variable inductor, a cat's whisker, and a filter capacitor. A crystal receiver is very simple and can be easy to make or even improvise, for example, the foxhole radio. However, the crystal radio needs a strong RF signal and a long antenna to operate.

  3. List of software-defined radios - Wikipedia

    en.wikipedia.org/wiki/List_of_software-defined...

    16 16 Yes Four dual channel, 16 bit, 370 MSPS ADCs; Two quad channel, 16 bit, 2500 MSPS DACs; 4/4 2x 10Gbit/s SFP+, Ethernet Yes Yes Yes Cross Country Wireless SDR receiver v. 3 [34] Pre-built 472 – 479 kHz, 7.0–7.3 MHz/10.10–10.15 MHz, and 14.00–14.35 MHz ext No External ADC required (I/Q output) 1/1 Crystal controlled two channels Yes Yes

  4. Power dividers and directional couplers - Wikipedia

    en.wikipedia.org/wiki/Power_dividers_and...

    Two-tone receiver test setup. If isolation is high, directional couplers are good for combining signals to feed a single line to a receiver for two-tone receiver tests. In figure 20, one signal enters port P 3 and one enters port P 2, while both exit port P 1.

  5. Radio receiver - Wikipedia

    en.wikipedia.org/wiki/Radio_receiver

    Another benefit of DSP is that the properties of the receiver; channel frequency, bandwidth, gain, etc. can be dynamically changed by software to react to changes in the environment; these systems are known as software-defined radios or cognitive radio. Many of the functions performed by analog electronics can be performed by software instead ...

  6. Modem - Wikipedia

    en.wikipedia.org/wiki/Modem

    It employed the most powerful coding techniques available at the time, including channel encoding and shape encoding. From the mere four bits per symbol ( 9.6 kbit/s ), the new standards used the functional equivalent of 6 to 10 bits per symbol, plus increasing baud rates from 2,400 to 3,429, to create 14.4, 28.8, and 33.6 kbit/s modems.

  7. Low-noise block downconverter - Wikipedia

    en.wikipedia.org/wiki/Low-noise_block_downconverter

    In the case of UK BSkyB receivers, the LNB remains powered while in standby so that the receiver can receive firmware updates and Electronic Programme Guide updates. In the United States, the LNB connected to a Dish Network receiver remains powered so the system can receive software and firmware updates and guide information over the air at night.

  8. Transmitter - Wikipedia

    en.wikipedia.org/wiki/Transmitter

    Commercial FM broadcasting transmitter at radio station WDET-FM, Wayne State University, Detroit, US.It broadcasts at 101.9 MHz with a radiated power of 48 kW.. In electronics and telecommunications, a radio transmitter or just transmitter (often abbreviated as XMTR or TX in technical documents) is an electronic device which produces radio waves with an antenna with the purpose of signal ...

  9. Crystal detector - Wikipedia

    en.wikipedia.org/wiki/Crystal_detector

    The crystal radio was the first type of radio receiver that was used by the general public, [14] and became the most widely used type of radio until the 1920s. [17] It became obsolete with the development of vacuum tube receivers around 1920, [ 1 ] [ 14 ] but continued to be used until World War II and remains a common educational project today ...