Search results
Results from the WOW.Com Content Network
(2) Shared FRS and GMRS simplex; GMRS repeater output. (3) GMRS repeater input. The output frequency of this repeater input is the input frequency minus 5 MHz. (4) FRS transmissions are limited to bandwidth of 11 kHz with a transmitter deviation of +/- 2.5 kHz. Channels are on 12.5 kHz centers. (5) GMRS transmissions may have a bandwidth of 16 ...
WIRES II - Yaesu did terminate WIRES-II service on Saturday, September 30, 2017 at 06:00 UTC. They suggested in the future, to use the WIRES-X Internet linking system. [2] [3] WIRES-X - Supports the C4FM digital and the voice technology. It enables high sound quality by repeating C4FM digital data as it is via the Internet.
In the 1930s vacuum tube repeaters using hybrid coils became commonplace, allowing the use of thinner wires. In the 1950s negative impedance gain devices were more popular, and a transistorized version called the E6 repeater was the final major type used in the Bell System before the low cost of digital transmission made all voiceband repeaters ...
In same-band repeaters, isolation between transmitter and receiver can be created by using a single antenna and a device called a duplexer. The device is a tuned filter connected to the antenna. In this example, consider a type of device called a band-pass duplexer. It allows, or passes, a band, (or a narrow range,) of frequencies.
A duplexer is an electronic device that allows bi-directional communication over a single path. In radar and radio communications systems, it isolates the receiver from the transmitter while permitting them to share a common antenna. Most radio repeater systems include a duplexer.
A duplex communication system is a point-to-point system composed of two or more connected parties or devices that can communicate with one another in both directions. Duplex systems are employed in many communications networks, either to allow for simultaneous communication in both directions between two connected parties or to provide a reverse path for the monitoring and remote adjustment ...
The duplexer is a device which prevents the repeater's high-power transmitter (on the output frequency) from drowning out the users' signal on the repeater receiver (on the input frequency). A diplexer allows two transmitters on different frequencies to use one antenna, and is common in installations where one repeater on 2 m and a second on ...
Reducing the delay of a wire by cutting it in half and inserting a repeater is known as repeater insertion. The cost of this procedure is the additional new delay through the repeater itself, plus power cost because the repeater is an active circuit that must be powered, whereas the plain unrepeated wire was originally an unpowered passive ...