Search results
Results from the WOW.Com Content Network
These brakes are now used on inexpensive bikes; before the introduction of dual-pivot caliper brakes they were used on all types of road bikes. Dual-pivot caliper brake. Dual-pivot side-pull caliper brakes are used on most modern racing bicycles. One arm pivots at the centre, like a side-pull; and the other pivots at the side, like a centre-pull.
A floating caliper (also called a "sliding caliper") moves side to side to the disc, along a line parallel to the axis of rotation of the disc; a piston on one side of the disc pushes the inner brake pad until it makes contact with the braking surface, then pulls the caliper body with the outer brake pad so the pressure is applied to both sides ...
A brake disc (or rotor in U.S. English), usually made of cast iron or ceramic, is connected to the wheel or the axle. To stop the wheel, friction material in the form of brake pads (mounted in a device called a brake caliper) is forced mechanically, hydraulically, pneumatically or electromagnetically against both sides of the disc. Friction ...
In manual transmission vehicles, the parking brake is engaged to help keep the vehicle stationary while parked, especially if parked on an incline. [2] [3]While automatic transmission vehicles have a "Park" gear with a parking pawl that immobilizes the transmission, it is still recommended to use the parking brake, as the pawl in the gearbox could fail due to stress or another vehicle striking ...
A Combined Braking System therefore distributes the brake force also to the non-braked wheel to lower the possibility of a lock-up, increase deceleration and reduce suspension pitch. With a single [rear] CBS the brake pressure applied on the rear brake (pedal) is simultaneously distributed to the front wheel.
Caliper is the American spelling, while calliper (double "L") is the British spelling. A single tool might be referred to as a caliper or as calipers — a plural only (plurale tantum) form, like scissors or glasses. Colloquially, the phrase "pair of verniers" or just "vernier" might refer to a vernier caliper.
Vernier caliper scales; main at top, vernier at bottom. It reads 3.58 ± 0.02 mm by adding 3.00 mm (left red mark) on the fixed main scale to vernier 0.58 mm (right red mark). The main scale reading is that to the left of the zero on the vernier scale. The vernier reading is found by locating the best aligned lines between the two scales.
Brakes: controls held in each of the pilot's hands connect to the trailing edge of the left and right sides of the wing. These controls are called brakes and provide the primary and most general means of control in a paraglider. The brakes are used to adjust speed, to steer (in addition to weight shift), and to flare (during landing).