Search results
Results from the WOW.Com Content Network
In the (2880)x480i case, the number of pixels on each line, and thus the number of times that they are repeated, is variable, and is sent to the DTV monitor by the source device. Increased Hactive expressions include “2x” and “4x” indicate two and four times the reference resolution, respectively.
It specifies a means for a computer to send commands to the monitor, as well as receive sensor data from the monitor, over a bidirectional link. Specific commands to control monitors are defined in a separate Monitor Control Command Set (MCCS) standard version 1.0, released in September 1998.
Drive: This command-line argument specifies the drive letter of the disk for which to display the volume label and serial number. Note: On Windows, the volume serial number is displayed only for disks formatted with MS-DOS version 4.0 or later. OS/2 allows the user to specify more than one drive. The vol command displays the volume labels ...
cmd.exe in Windows NT 2000, 4DOS, 4OS2, 4NT, and a number of third-party solutions allow direct entry of environment variables from the command prompt. From at least Windows 2000, the set command allows for the evaluation of strings into variables, thus providing inter alia a means of performing integer arithmetic.
The first version of the MIPI DSI, version 1.0 was released in 2005. MIPI DSI v1.1 was released in 2007, and added features such as "Command Mode" for directly sending commands and data to display modules using the display controller. [1] DSI v1.2 was released in 2011, and extended the video packet length and expanded the command mode. [2]
It is possible to select the input source using a VCP command. Some monitors will only take VCP commands from the active input source, others will take commands from any connected input source. Three categories of controls exist: Continuous (C) Allow values between zero and a maximum value. Non-continuous (NC) Only support a limited set of values.
For Intel Pentium III CPUs, the serial number is returned in the EDX:ECX registers. For Transmeta Efficeon CPUs, it is returned in the EBX:EAX registers. And for Transmeta Crusoe CPUs, it is returned in the EBX register only. Note that the processor serial number feature must be enabled in the BIOS setting in order to function.
In computing, serial presence detect (SPD) is a standardized way to automatically access information about a memory module. Earlier 72-pin SIMMs included five pins that provided five bits of parallel presence detect (PPD) data, but the 168-pin DIMM standard changed to a serial presence detect to encode more information.