enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Torx - Wikipedia

   en.wikipedia.org/wiki/Torx

   A security Torx L-key and fastener with holes for a safety pin to hinder disassembly with an ordinary Torx key. A Torx T8 screw head on a hard disk drive.. Torx (pronounced / t ɔːr k s /) is a trademark for a type of screw drive characterized by a 6-point star-shaped pattern, developed in 1967 [1] by Camcar Textron.

3. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   A security Torx screw drive is a common modification to socket and cruciform style drives to make the fastener more tamper resistant by inserting a pin in the center of the female socket, requiring a tool with a corresponding hole to drive the fastener. This can also prevent attempts at turning the screw with a small flat-bladed screwdriver.

4. Torque screwdriver - Wikipedia

   en.wikipedia.org/wiki/Torque_screwdriver

   A torque screwdriver is a screwdriver with components that ensure tightening to a specified torque, ensuring tightening which is sufficient, but not excessive. An insufficiently tightened screw connection may loosen in operation, and excessive tightening can damage parts; for example, if the nuts holding the wheel of a car in place are too ...

5. Robertson screw - Wikipedia

   en.wikipedia.org/wiki/Robertson_screw

   Screwdriver bits in different sizes for Robertson screws. When Henry Ford tried the Robertson screws, he found that they saved considerable time in Model T production. When Robertson refused to license the design, Ford realized that the supply of screws would not be guaranteed, and chose to limit their use to his Canadian division. [4] [5] [6]

6. Computer case screws - Wikipedia

   en.wikipedia.org/wiki/Computer_case_screws

   Usually, the standoff has a #6-32 UNC male thread on one end which screws into a threaded hole in the case or motherboard backplate and a #6-32 UNC female thread in the other end which accepts a screw to retain the motherboard. Less often, the standoff has a female thread in both ends and a second screw is used to attach it to the case.

7. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole should be 1/2" longer than the depth penetration of the screw.