Search results
Results from the WOW.Com Content Network
In generic terms, a stick pusher is known as a stall identification device or stall identification system. [73] A stick shaker is a mechanical device that shakes the pilot's controls to warn of the onset of stall. A stall warning is an electronic or mechanical device that sounds an audible warning as the stall speed is approached. The majority ...
A compressor stall is a local disruption of the airflow in the compressor of a gas turbine or turbocharger. A stall that results in the complete disruption of the airflow through the compressor is referred to as a compressor surge. The severity of the phenomenon ranges from a momentary power drop barely registered by the engine instruments to a ...
The almost uniform lift distribution of a constant-aerofoil section elliptical wing can cause the entire span of the wing to stall simultaneously, potentially causing loss of control with little warning. To improve the stalling characteristics and give the pilot some warning, designers use a non-uniform aerofoil.
Twisting the outer leading edge down to reduce the incidence of the wing tip, which is behind the main centre of lift. This also improves stall characteristics and can benefit supersonic cruise in other ways. Moving the centre of mass forwards and trimming the elevator to exert a balancing downforce.
The key difference between a pure aerodynamic fighter and a supermaneuverable one is generally found in its post-stall characteristics. A stall, as aforementioned, happens when the flow of air over the top of the wing becomes separated due to a high angle of attack (this can be caused by low speed, but its direct cause is based on the direction ...
One problem with the forward-swept design is that when a swept wing yaws sideways (moves about its vertical axis), one wing retreats while the other advances. On a forward-swept design, this reduces the sweep of the rearward wing, increasing its drag and pushing it further back, increasing the amount of yaw and leading to directional instability.
A stall strip is a small component fixed to the leading edge of the wing of an airplane to modify its aerodynamic characteristics. [1] These stall strips may be necessary for the airplane to comply with type certification requirements.
Wing loading is a useful measure of the stalling speed of an aircraft. Wings generate lift owing to the motion of air around the wing. Larger wings move more air, so an aircraft with a large wing area relative to its mass (i.e., low wing loading) will have a lower stalling speed.