Search results
Results from the WOW.Com Content Network
In the modern standard metric version, it is simply a size number, where listed diameter size is the major outer diameter of the external thread. For a taper thread, it is the diameter at the "gauge length" (plus/minus one thread pitch) from the small end of the thread.
Whitworth's new standard specified a 55° thread angle and a thread depth of 0.640327p and a radius of 0.137329p, where p is the pitch. The thread pitch increases with diameter in steps specified on a chart. The Whitworth thread system was later to be adopted as a British Standard to become British Standard Whitworth (BSW).
Pipe Threads, General Purpose (Inch) Pipe Thread Form ANSI B1.20.3-1976 (R2013) Dryseal Pipe Threads (Inch) Pipe Thread Form ASME B1.20.7-1991 (R2013) Hose Coupling Screw Threads - Inch: Pipe Thread Form ASME B1.21M-1997 (R2013) Metric Screw Threads - MJ Profile: V Thread Form BS 84: Tables of BS Whitworth, BS Fine and BS Pipe Threads: V Thread ...
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
British standard pipe thread: G 55° DIN / BS / EN / ISO 228-1 / ISO 7-1 National Pipe Thread NPT 60° ASME B1.20.-1983 Pipe Threads, General Purpose, Inch
BS 92 Screw threads, British Standard Whitworth and their tolerances; BS 93 Specification for British Association (B.A.) screw threads with tolerances for sizes 0 B.A. to 16 B.A. BS 94 Watertight glands for electric cables; BS 95 Tables of Corrections to Effective Diameter required to compensate Pitch and Angle Errors in Screw Threads of ...
The major minus pitch technique also works for inch-based threads, but you must first calculate the pitch by converting the fraction of threads-per-inch (TPI) into a decimal. For example, a screw with a pitch of 1/20 in (20 threads per inch) has a pitch of 0.050 in and a 1 ⁄ 13 in pitch (13 threads per inch) has a pitch of 0.077 in.
BS 93:1951 — Specification for British Association (B.A.) screw threads with tolerances for sizes 0 B.A. to 16 B.A. BS 93:2008 — British Association (B.A.) screw threads — Requirements; The angle of the thread is 47.5° [4]: 2 and the depth of thread is 0.6 times the