enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Four-terminal sensing - Wikipedia

   en.wikipedia.org/wiki/Four-terminal_sensing

   Four-point measurement of resistance between voltage sense connections 2 and 3. Current is supplied via force connections 1 and 4. In electrical engineering, four-terminal sensing (4T sensing), 4-wire sensing, or 4-point probes method is an electrical impedance measuring technique that uses separate pairs of current-carrying and voltage-sensing electrodes to make more accurate measurements ...

3. LCR meter - Wikipedia

   en.wikipedia.org/wiki/LCR_meter

   Lower end meters might offer the possibility to externally supply these DC voltages or currents while higher end devices can supply them internally. In addition benchtop meters typically allow the usage of special fixtures (i.e., Kelvin wiring, that is to say, 4-wire connections) to measure SMD components, air-core coils or transformers.

4. Kelvin bridge - Wikipedia

   en.wikipedia.org/wiki/Kelvin_bridge

   The operation of the Kelvin bridge is very similar to the Wheatstone bridge, but uses two additional resistors. Resistors R 1 and R 2 are connected to the outside potential terminals of the four terminal known or standard resistor R s and the unknown resistor R x (identified as P 1 and P′ 1 in the diagram).

5. Megger Group Limited - Wikipedia

   en.wikipedia.org/wiki/Megger_Group_Limited

   Megger is known for its electrical insulation testers. It supplies products related to the following areas: cable fault locating, earth/ground testing, low resistance measuring, power quality, electrical wiring, insulation testers, multimeters, portable appliance testers, clamp-on meters, current transformers, etc.

6. List of electrical and electronic measuring equipment

   en.wikipedia.org/wiki/List_of_electrical_and...

   Creates constant-amplitude variable frequency sine waves to test frequency response Transistor tester: Tests transistors Tube tester: Tests vacuum tubes (triode, tetrode etc.) Wattmeter: Measures power in a circuit Vectorscope: Displays the phase of the colors in color TV Video signal generator: Generates video signal for testing purposes Voltmeter

7. Cartridge heater - Wikipedia

   en.wikipedia.org/wiki/Cartridge_heater

   The nichrome wire is wound around a ceramic core, and the number of spirals per inch vary according to the requested watt density. Potential from an alternating current source, which can either be 2 phase or 3 phase, flows through the coiled nichrome wire, heating up the wire, which in turn, heats the cartridge heater sheath.

8. Free Online Games: Play board games, card games, casino ... - AOL

   www.aol.com/games

   Discover the best free online games at AOL.com - Play board, card, casino, puzzle and many more online games while chatting with others in real-time.

9. Electric heating - Wikipedia

   en.wikipedia.org/wiki/Electric_heating

   An electric heater is an electrical device that converts an electric current into heat. [1] The heating element inside every electric heater is an electrical resistor , and works on the principle of Joule heating : an electric current passing through a resistor will convert that electrical energy into heat energy.