Search results
Results from the WOW.Com Content Network
Materials or systems exhibiting multiple phases (such as composites or heterogeneous materials) commonly show a universal dielectric response, whereby dielectric spectroscopy reveals a power law relationship between the impedance (or the inverse term, admittance) and the frequency, ω, of the applied AC field.
The EI-EPR spectra can be collected in two ways: (1) difference spectra [7] (2) frequency modulated rf field without Zeeman modulation. This technique was established by Hyde [ 7 ] and is especially useful for separating overlapping EPR signals which result from different radicals, molecular conformations or magnetic sites.
SASERs could have wide applications. Apart from facilitating the investigation of terahertz-frequency ultrasound, the SASER is also likely to find uses in optoelectronics (electronic devices that detect and control light—as a method of transmitting a signal from an end to the other of, for instance, fiber optics), as a method of signal modulation and/or transmission.
Coulometry uses applied current or potential to convert an analyte from one oxidation state to another completely. In these experiments, the total current passed is measured directly or indirectly to determine the number of electrons passed. Knowing the number of electrons passed can indicate the concentration of the analyte or when the ...
This last equation is used to determine in an EPR experiment by measuring the field and the frequency at which resonance occurs. If g {\displaystyle g} does not equal g e {\displaystyle g_{e}} , the implication is that the ratio of the unpaired electron's spin magnetic moment to its angular momentum differs from the free-electron value.
Resonant ultrasound spectroscopy (RUS) is a laboratory technique used in geology and material science to measure fundamental material properties involving elasticity. This technique relies on the fact that solid objects have natural frequencies at which they vibrate when mechanically excited.
In a typical spectrum analyzer there are options to set the start, stop, and center frequency. The frequency halfway between the stop and start frequencies on a spectrum analyzer display is known as the center frequency. This is the frequency that is in the middle of the display's frequency axis.
If the frequency deviation is held constant and the modulation frequency increased, the spacing between spectra increases. Frequency modulation can be classified as narrowband if the change in the carrier frequency is about the same as the signal frequency, or as wideband if the change in the carrier frequency is much higher (modulation index ...